Operation Manual

Initial Set-up

Note: Brief pressure on the on/off button will be

enough to switch the device on or off, provided that

your navigation system is connected to an external

source of electricity or is running in battery opera-

tion.

Press the on/off button for 6 seconds, if it is in-

tended to switch off the device completely. It will be

switched on again by pressing the on/off button for

approx. 3 seconds, as mentioned above.

No data will be lost during this because of the storage

of data in the internal memory. The starting process

will only last slightly longer

Note: Your device will be delivered in a status in

which it will not switch off independently.

You can adjust the period of operation to suit your

needs using the Settings button on the main screen

of your device.

III. Installing the Navigation software

Your device has already been equipped with the basic data of the

navigation software at the factory and the final installation of the

navigation software will take place automatically from the internal

memory. Follow the onscreen instructions.

The memory card must always be inserted in the device while the

navigation system is being used. It will be necessary to carry

out a Soft Reset to restart the navigation system if the memory

card has been removed, only for a short time, while the system

was being used (see page 23).

Please also read the chapter Navigation starting on page 24.