Owner's Manual
Table Of Contents
- Instruction Manual
- Reset
- Demo Mode
- Clock Set
- Bluetooth PIN (0000)
- Attaching / Removing Faceplate
- Table of Contents
- Parts & Controls
- Basic Operation
- Getting Started
- Radio Operation
- USB / iPod / Android Operation
- Pandora
- iHeartRadio
- Spotify
- SiriusXM Radio (for KD-X350BTS / KD-X35MBS)
- Bluetooth
- AUX Input
- Audio Settings
- Display Settings
- Troubleshooting
- Specs
- Installation / Connections
- Fixing Faceplate to Unit
- Warranty
ENGLISH
38
Part list for installation
Basic procedure
1
Remove the key from the ignition switch, then
disconnect the
terminal of the car battery.
2
Connect the wires properly.
See Wiring connection.
( 39)
3
Install the unit to your car.
See Installing the unit (in-dash mounting).
4
Connect the terminal of the car battery.
5
Press to turn on the power.
6
Detach the faceplate and reset the unit within 5 seconds.
( 3)
Installing the unit (in-dash mounting)
How to remove the unitWhen installing without the mounting sleeve
1
Remove the mounting sleeve and trim plate from the unit.
2
Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with screws
(commercially available).
Use only the specified screws. Using wrong screws might
damage the unit.
Do the required wiring.
(
39)
Bend the appropriate tabs to hold
the sleeve firmly in place.
Hook on the top side
Orientate the trim
plate as illustrated
before fitting.
Dashboard of
your car
(A)
Faceplate
(C)
Mounting sleeve
(B)
Trim plate
(D)
Wiring harness
(E)
Extraction key
INSTALLATION/CONNECTION
JS_JVC_KD_X350BTS_K_EN_5.indd 38 7/5/2017 9:56:03 AM