Operation Manual

Installation/Connection Manual
204
The unit inclination can now be selected in degrees by turning the right
rotary control and pressing to confirm.
The number of wheel impulses per wheel revolution (if known) can then
be selected by turning the right rotary control and pressing to con-
firm.
The previously entered data is displayed once more. If the data entered
is correct, press the right rotary control .
If correction is necessary, select
MODIFY by turning the right rotary
control and press to confirm. The values can then be re-entered.
Once the previously entered data has been confirmed, the tyre data can
be entered or self-calibration can be started.
To enter the tyre data, select
INPUT TYRE VALUES by turning the
right rotary control and press to confirm.
)
Unit rotation corresponds to horizontal rotation. A positive val-
ue means rotation of the front of the unit towards the driver
(LHD).
)
Unit inclination corresponds to vertical inclination. A positive
value means upward inclination of the front of the unit.
)
If the number of wheel impulses per wheel revolution is not
known,
UNKNOWN must be selected. It is then not possible to
enter tyre data.
EN185-209_Install.fm Page 204 Wednesday, June 2, 2004 5:32 PM