Operation Manual

Installation/Connection Manual
203
Changing the calibration (
CALIBRATION)
Deleting the calibration:
If the navigation system is removed from one vehicle and installed in
another, the calibration must be performed again. However, to do so, the
current calibration data must be deleted.
In the Service Mode, select
CALIBRATION with the right rotary
control and press to confirm.
With the right rotary control , select
DELETE and press to confirm.
The calibration is deleted and the unit returns to the Service Mode.
Calibration setting:
It is possible to provide calibration settings.
In the Service Mode, select
CALIBRATION with the right rotary
control and press to confirm.
With the right rotary control , select
MODIFY and press to confirm.
Unit rotation can be selected in degrees by turning the right rotary
control and pressing to confirm.
)
Calibration settings should only be made when the values to be
entered are known. The unit cannot perform correct route cal-
culations if incorrect values are entered.
EN185-209_Install.fm Page 203 Wednesday, June 2, 2004 5:32 PM