Operation Manual

Installation/Connection Manual
196
Using GPS for the first time, and sensors
• Switch on the vehicle ignition to start using GPS for the first time
and for the sensor test. Switching on the unit. Enter the code (see
the operation guide for a detailed description).
• Press multifunction button and multifunction button
at the same time.
• This calls up the menu for the initial GPS start-up and for the sen-
sor test.
• Move the vehicle several metres forwards or backwards for the
speed signal function test.
• Engage the reverse gear for the reverse signal function test.
)
The number under Speed must change (even at a low speed).
The number under
Speed should not increase when idling or
pressing the accelerator when the vehicle is parked.
)
The arrows under Direction must change direction on en-
gaging the reverse gear.
EN185-209_Install.fm Page 196 Wednesday, June 2, 2004 5:32 PM