Operation Manual

31
ENGLISH
When Security Lock works?
Once you register the password, “ ”
appears on the display, and the unit will ask you
to enter the password in the following cases:
• When you turn on the unit for the first time after
re-installing the unit.
• When you turn on the unit for the first time after
replacing the car battery.
To use this unit, you must enter the correct
password by following the procedure below.
1 Press DISP (display) to select the character set
you want.
2 Turn the control dial to enter a character.
3 Press ¢ or 4 to move the character
entry position.
4 Repeat steps 1 to 3 to enter the entire password
(4 letters) correctly, then press SEL (select).
• If you enter the correct password, the security
lock is canceled and you can use the unit
normally.
• In the following cases, the security lock is not
canceled (“NOT ACCEPT” appears on the
display) then the unit turns off. (The unit will
never turn on unless you press the reset button
on the front panel. See page 2.)
– If you enter an incorrect password then press
SEL (select).
– If you cannot finish entering the correct
password within 30 seconds.
If you enter an incorrect character while
entering the password
Press 4 to move back the character entry position
over the incorrect character, then repeat steps 1 and 2
to select the correct character.
To change the password
If you want to change the password after you have
registered it, follow the procedure below.
1 Press SEL (select) and ¢ at the same
time for more than 2 seconds.
“ ” appears on the display.
2 Enter the current password correctly, then press
SEL (select).
The unit enters password entry mode.
3 Enter a new password as you want, then press
SEL (select).
The password flashes on the display for a while,
then the unit returns to the normal operation
mode.
• See page 30 for details on how to enter the
password.
EN22-31.KD-LX330R[E]f 2/5/01, 10:11 AM31