Operation Manual

20
ENGLISH
Using the sound control
memory
You can select and store a preset sound
adjustment suitable for each playback source.
(Advanced SCM)
Selecting and storing the sound
modes
Once you select a sound mode, it is stored in
memory. It will be recalled every time you select
the same source and will be shown on the
display.
A sound mode can be stored for each of the
following sources — FM1, FM2, FM3, AM, CD
and external components.
• If you do not want to store the sound mode
separately for each playback source, but want
to use the same sound mode for all the
sources, see “To cancel Advanced SCM
— SCM LINK” on page 24.
1 Press MODE BAND.
The number buttons can work
as different function buttons.
2 Select the sound mode you want.
Each time you press the button,
the sound mode changes as
follows:
• When “SCM LINK” is set to “SCM LINK ON,” the
selected sound mode can be stored in memory
for the current source and the effect applies only
to the current source. Each time you change the
playback source, the SCM indicator flashes on
the display.
• When “SCM LINK” is set to “SCM LINK OFF,”
the selected sound mode effect applies to any
source.
What is BBE
II
?
The BBE
II
* function restores the brilliance and clarity
of the original live sound in recording, broadcasts,
etc.
When a speaker reproduces sound, it introduces
frequency-dependent phase shifting, causing high-
frequency sounds to take longer to reach the ear
than low frequency sounds. The BBE
II
function
adjusts the phase relationship between the low, mid
and high frequencies by adding a progressively
longer delay time to the low and mid frequencies,
so that all frequencies reach the listener’s ears at
the proper time.
In addition, the BBE
II
function boosts low and high
frequencies, which loudspeakers tend to be less
efficient in reproducing, through dynamic, program-
driven augmentation. When combined with the
phase compensation feature, the resulting sound
has a clearer, more finely detailed “live” presence.
As you turn the control dial, the BBE
II
function
changes as follows:
As the number gets higher, the BBE
II
function
becomes stronger.
When shipped from the factory, the BBE
II
function
is set to “BBE 2.”
To cancel the BBE
II
function, select “BBE OFF.”
* Under license from BBE Sound, Inc.
R
is a trademark of BBE Sound, Inc.
SCM BEAT SCM SOFT
SCM OFF
SCM POP
BAND
BBE 1 BBE 2
BBE OFF
(Canceled)
BBE 3
(1) (2)
Canceled
(OFF)
(3)
EN19-21.KD-LX330R[E]f 2/5/01, 10:11 AM20