Operation Manual

15
ENGLISH
Changing the display mode while
listening to an FM station
You can change the initial indication on the display
to either station name (PS NAME) or to station
frequency (FREQUENCY), while listening to an FM
RDS station.
• See also “Changing the general settings (PSM)”
on page 22.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
2 Press ¢ or 4 to select “TUNER
DISP” (tuner display).
3 Turn the control dial to set to the desired indication
(“PS NAME” or “FREQUENCY”).
4 Press SEL (select) to finish the setting.
Note:
By pressing DISP, you can also change the display while
listening to an FM RDS station.
Each time you press the button, the following information
appears on the display:
• Then, the display goes back to the original indication
in several seconds.
Setting the TA volume level
You can preset the volume level for TA Standby
Reception. When a traffic programme is received,
the volume level automatically changes to the
preset level.
• See also “Changing the general settings (PSM)”
on page 22.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
2 Press ¢ or 4 to select “TA VOLUME.”
3 Turn the control dial to set to the desired volume.
You can set it from “VOL 00” to “VOL 50.”
4 Press SEL (select) to finish the setting.
Automatic clock adjustment
When shipped from the factory, the clock built in
this unit is set to be readjusted automatically using
the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock
adjustment, follow the procedure below.
• See also “Changing the general settings (PSM)”
on page 22.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
2 Press ¢ or 4 to select “AUTO
ADJUST.”
3 Turn the control dial to select “ADJUST OFF.”
Now automatic clock adjustment is canceled.
4 Press SEL (select) to finish the setting.
To reactivate clock adjustment, repeat the same
procedure and select “ADJUST ON” in step 3.
Note:
You must stay tuned to the same station for more than 2
minutes after setting “AUTO ADJUST” to “ADJUST
ON.” Otherwise, the clock time will not be adjusted. (This
is because the unit takes up to 2 minutes to capture the
CT data in the RDS signal.)
Station Frequency
(FREQUENCY)
Station name
(PS NAME)
Programme type
(PTY)
EN11-15.KD-LX330R[E]f 2/5/01, 10:13 AM15