User Guide

48
ENGLISH
EXTERNAL COMPONENT OPERATIONS
Playing an external component
When connecting an external component to the LINE IN plugs on the rear, you can select the
component as the sound source.
1
Select the external component.
Each time you press the button, the source changes as described on
page 5.
2
Operate the external component.
Notes:
• For the external component connection, see the Installation/Connection Manual (separate volume).
• See also “Assigning names to the sources” on page 36 if you want to match the name shown on the
display with the name of the connected component.
Using a subwoofer
By connecting a subwoofer to the SUBWOOFER OUT plugs on the rear, you can enjoy
enhanced bass sounds and a more realistic theater atmosphere in your car.
• Refer also to the instructions supplied with your subwoofer.
To set the subwoofer cutoff frequency, follow the procedure below.
When a subwoofer is connected to this unit, select an appropriate cutoff frequency level for your
subwoofer. When shipped from the factory, the subwoofer cutoff frequency is set to “MID.”
• FREQ LOW: Frequencies higher than 50 Hz are cut off to the subwoofer.
• FREQ MID: Frequencies higher than 80 Hz are cut off to the subwoofer.
• FREQ HIGH: Frequencies higher than 120 Hz are cut off to the subwoofer.
1 Press and hold SEL (Select) for more than 2 seconds so that one of the PSM items
appears on the display.
2 Press
¢ or 4 repeatedly until “WOOFER FREQ” appears on the display.
3 Press + or – to select the desired cutoff frequency.
4 Press SEL again to finish the setting.
To adjust the subwoofer output volume, see “Adjusting the sound” on page 24.
1
EN48-48.KD-LX30R[E]/1 00.1.12, 2:28 PM48