Manual

Recordin
IMPORTANT:
• It should be noted that it may be unlawful to re-record
pre-recorded tapes, records, or discs without the
consent of the owner of copyright in the sound or video
recording, broadcast or cable programme and in any
literary; dramatic, musical, or artistic embodied
therein.
• The recording level is automatically set correctly, so it is
not affected by the VOLUME, the SUBWOOFER LEVEL,
and the SOUND MODE controls. Thus, during recording
you can adjust the sound you are actually listening to
without aflbcting the recording level.
• If there are excessive noise or s'tatic in the recording you
have made, the unit may be too close to a TV. Increase the
distance between the TV and the unit.
• You can use type I 'tape fbr recording.
Toprotectyourrecording
Cassettes have two small 'tabs
on the back to protect from
unexpected erasure or re-
recording.
To protect your recording,
remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive 'tape.
Tokeepthe bestrecordingand playbacksound
quality
If the heads, caps'tans, andpinch rollers of the cassette deck
become dirty, the fbllowing will occur:
• Impaired sound quality,
• Discontinuous sound
• Fading
• Incomplete erasure
• Difficulty in recording
To clean the heads, capstans, and pinch rollers
Use a cotton swab moistened with alcohol.
Recordingona Tape
1 Press _ EJECT to insert a recordable cassette
with the exposed part of the tape down.
2 Close the cassette holder gently.
• If you want to record on both sides of a 'tape, see "To
record on both sides Reverse Mode."
3 Check the tape direction of the cassette deck.
• If the tape direction is not correct, press TAPE _ I_ twice
then • to change the 'tape direction.
4 Start pla)4ng the source---FM, AM, CD playel;
or auxilim_ _equipment connected to AUX jacks.
• When the source is CD, you can also use CD Direct
Recording (see page 20), andAuto Edit Recording
(see page 21).
5
Start recording.
On the unit:
Press REC START/STOP.
R_C START
! STOP
%
On the remote control:
Press and hold REC START/STOP
tbr more than 1 second.
The REC (recording) lamp flashes when recording s'tartsand
the 'tapedirection indicator (1_ or _) s'tarts flashing slowly.
• If no cassette is inserted, "NO TAPE" appears on the
display,. If a protected 'tape is inserted, "NO REC"
appears on the display,.
Pinch rollers
Capstans /
Heads
To demagnetize the heads
Turn off the unit, and use a head demagnetizer (a_-ailable at
electronics and audio shops).
To stop recording immediately, press REC START/STOP or
• (or press and hold REC START/STOP on the remote control
fbr more than 1 second).
To remove the cassette, press _AEJECT to open the cassette
holder.
Torecordonbothsides--Reverse Mode
On the unit ONLY:
Press REVERSE MODE so that the Reverse Mode ......_o_
indicator on the display, lights up like (Z).
\
• When using the Reverse Mode fbr recording,
s'tart recording in the fbrward (1_) direction
first. Otherwise, recording will stop when
recording is done only on one side (reverse) of the tape.
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator on the display lights up like _".
-19-