Manual

PlayingBackCDs(CD/CD-R/CD-RW)
This unit has been designed to play;back the following CDs:
• CD (Audio CD)
• CD-R (CD-Recordable)
• CD-RW (CD-ReWritable)
Continued use of irregular shape CDs
(heart-shape, octagonal, etc.) can damage
the unit.
x@
x@
Whenplayinga CD-Ror CD-RW
User-edited CD-Rs (CD-Recordable) and CD-RWs
(CD-ReWritable) can be played back only if the), are already,
"finalized."
• You can play, back ),our original CD-Rs or CD-RWs
recorded in music CD fbrmat. (IIowever, the), may not be
played back depending on their characteristics or recording
conditions.)
• Before playing back CD-Rs or CD-RWs, read their
instructions or cautions carefully.
• Some CD-Rs or CD-RWs may not be played back on this
unit because of their disc characteristics, damage or stain
on them, or the player's lens is dirt),.
• CD-RWs may require a longer readout time. This is caused
by, the fhct that the reflectance of CD-RWs is lower than fbr
regular CDs.
LoadingCDs
On the unit ONLY:
1
Press _ ibr the disc tray
(CD1, CD2, and CD3) you
want to load a CD onto.
The unit automatically turns on
and the disc tray comes out.
2 Place a disc correctly on the circle of the disc
tray, with its label side up.
4 Repeat steps I to 3 to place other CDs.
_ When loading more than one CD continuously
When you press • for the next tray you want to place another CD
onto, the first disc tray automatically closes and then the next tray
comes out.
AbouttheCD readylamps
Each CD read), lamp corresponds to the disc tray, of the
same number.
• _rhen and why they light up?
When you turn on the unit for the first time after
plugging into a wall outlet, all CD read), lamps (CD1
READY, CD2 READY, and CD3 READY) lights up.
From the next time on, CD ready lamp(s) light(s) up
according to the previous condition.
Each time youpress the CD eject buttons & (CD1,
CD2, and CD3), the corresponding CD read), lamp
lights up.
Brhen and why they go oft7
Only when the unit detects there is no CD loaded on
the tray; the corresponding CD read), lamp goes off.
("NO DISC 1;' "NO DISC 2," or "NO DISC 3"
appears on the display,.)
Brhen and why they flash?
The corresponding CD ready lamp flashes during
playback and pause.
I
CORRECT INCORRECT
• When using a CD single (8 cm), place it on the inner
circle of the disc tray.
3 Press the same _ you have
pressed in step 1.
The disc tray, closes.
-13-