Operation Manual
Continued I_
UsingRecordingTimer
With Recording Timer, you can make a tape of a radio
broadcast automatically.
How RecordingTimer actuallyworks
The unit automatically turns on, tunes in to the specified
station, sets the volume level to "VOLUME MIN," and starts
recording when the on-time comes. ("REC" and the REC
indicator flash just before the on-time, and the REC indicator
continues flashing while the timer is operating). Then, when
the off-time comes ("REC OFF" appears just before the off-
time), the unit automatically turns off (on standby).
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step ,2 again.
• To correct a misentry while setting the timer, press
CANCEL/DEMO.
On the unit ONLY:
1 Insert a recordable cassette with the exposed
part of the tape down.
2 Press CLOCK/TIMER _o_
repeatedly until "REC"
appears on the display.
The @ (Timer) indicator lights up andthe REC (Recording
Timer) indicator also starts flashing on the display.
PE[
• Each time you press the button, the timer setting modes
change as follows:
DAILY "-_ TIMER --"
_" (Daily Timer setting) j
L_ Canceled --,- Clock 4- TIMER
setting (Recording Timer setting)
(The hour digits start flashing.)
3 Press CLOCK/TIMER again.
"TIMER" appears for 2 seconds, then the
unit enters on-time setting mode.
A AAAA
I--II_I I_II_d I I--I
I_II_I I I I LI
TTTT
4 Set the on-time you want the
unit to turn on at.
1) Turn _ / _ to set the hour, then
press SET/DISPLAY.
"SET" appears for 1 second.
2) Turn _ / _ to set the minute,
then press SET/DISPLAY.
"SET" appears for 1 second, then
the unit enters off-time setting mode.
SET/
DISPLAY
uFF ,,, u
TTTTT
5 Set the off-time you want the unit to turn off
(on standby) at.
1) Turn _ / _ to set the hour, then press
SET/DISPLAY.
"SET" appears for 1 second.
2) Turn _ / _ to set the minute, then press
SET/DISPLAY.
"SET" appears for 1 second, then the unit enters preset
station selecting mode.
6 Select the preset station.
1) Turn _ / _ to select the band ("TUNER FM" or
"TUNER AM"), then press SET/DISPLAY.
"SET" appears for 1 second.
2) Turn _ / _ to select a preset channel number,
then press SET/DISPLAY.
The REC (Recording Timer) indicator stops flashing
and remains lit. "OK _/" appears on the display for
2 seconds.
The settings you have done are shown on the display
in sequence for your confirmation.
7 Press Oil to turn off the unit (on
standby) if necessary.
• If you want to listen to another source whilerecording
PressREC START/STOPor • to stop recording. Without
stopping it, you cannot change thesource.
• Even ifyou unplug theAC power cord or if a power failure
occurs
Once you set the timer, thetimersetting may remain stored in
memoryfor a few days. In thiscase, checkwhether the timer
setting still remains ornot.
- 26 -