Operation Manual

Programmingthe PlayingOrderoftheTracks
--Program Play
You can arrange the playing order of the tracks before you
start playing. You can program up to 50 tracks.
• To use Repeat Play (see page 19) for Program Play, press
REPEAT after starting Program Play. Only REPEAT 1 and
REPEAT ALL can be selected for Program Play.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step ,2 again.
1 Load discs.
• If the current playing source is not the CD player, press
CD _/ll, then • before going to the next step.
2 Activate the Program Play mode.
On the unit:
Press CD PLAY MODE repeatedly %#*
until "CD PROGRAM" appears on
the display.
• Each time you press the button, the play
mode changes as follows:
/ ......... _!!celedC RANDOM
(Continuous Play)
On the remote control:
Press PROGRAM so that
"CD PROGRAM" appears
on the display.
I- TI
I_±1
PROGRAM
PnQM
PR'-'- '-'""ugF',
f"i I ............................
• The PRGM (program) indicator lights up on the display.
3 Press one of the disc number
(CD1, CD2, or CD3) buttons
to select the disc you want to
play.
Disc number
co3
CD2CD1
Track number
PnQM
oo oo
ILl'" j...........................
Program step number
4 Select a track from the selected
disc in the above step.
On the unit:
Turn I_< / _ to select the
track number, then press
SET/DISPLAY.
SET/
DISPLAY
%
On the remote control:
Press the number buttons.
• For how to use the number
buttons, see "To go to another
track directly using the number
buttons" on page 16. O O O
5 Program other tracks you want.
• To program tracks from the same disc, repeat step 4.
• To program tracks from a different disc, repeat steps 3
and 4.
6 Press CD I_/11.
The tracks are played in the order you
have programed.
• If the playing disc is an MP3 disc,
the MP3 indicator lights up.
o%
To stop playing, press •.
To exit from Program Play mode, press CD PLAY MODE
repeatedly until the PRGM (program) indicator goes off (or
press PROGRAM on the remote control) after playback
stops.
• If you try to program a 51 st track, "CD FULL" will be flashing on
the display.
• If you have tried to program a track from an empty tray, "NO
DISC 1," "NO DISC 2," or "NO DISC 3" will appear on the
display for 2 seconds.
• If the track number you have programed does not exist on the
disc, it will be skipped during play.
-17-