User Guide

EN3
Windows
ENGLISH
Operating Environment
CAUTION:
● Operate this equipment according to the operating procedures described in this manual.
● Use only the provided CD-ROM. Never use any other CD-ROM to run this software.
● Do not attempt to modify this software.
● Changes or modifications not approved by JVC could void user’s authority to operate the
equipment.
How to handle a CD-ROM
n Take care not to soil or scratch the mirror surface (opposite to the printed surface). Do not
write anything or put a sticker on either the front or back surface. If the CD-ROM gets dirty,
gently wipe it with a soft cloth outward from the centre hole using a circular motion.
n Do not use conventional disc cleaners or cleaning spray.
n Do not bend the CD-ROM or touch its mirror surface.
n Do not store your CD-ROM in a dusty, hot or humid environment. Keep it away from
direct sunlight.
CAUTION:
This software cannot be used with the GC-S1 Digital Still Camera.
q Personal Computer with Microsoft
®
Windows
®
95
q CPU i486DX2/66MHz or higher processor (Pentium or better is
recommended.)
q Minimum RAM requirement : 16 MB
q Available Hard Disk space of at least 63 MB
(DS SERIAL TWAIN Driver: 25MB, MGI PhotoSuite SE: 38 MB)
q Colour display capable of at least 640 x 480 pixels, 256 colours
Recommended 1280 x 1024, 65000 colours
q 1 free serial transmission port, compatible with 9600 bps or higher trans-
mission rate, connectable to RS-232C with 9 pin serial connector
(Recommended compatible with UART 16550A)
q Mouse (Windows
®
compatible)
q CD-ROM drive
* Microsoft
®
and Windows
®
are either registered trademarks or trademarks of
Microsoft Corporation in the United States and/or other countries.
* Other product and company names included in this instruction manual are
trademarks and/or registered trademarks of their respective holders.
NOTE An optional 9 pin serial conversion adapter is required for compu-
ters using a serial communication port other than a standard 9 pin.
GETTING STARTED