User manual

9
Type
For setting the system to transfer videos for
distribution.
[Setting Values: RMPEG2-TS/UDP, MPEG2-TS/
TCP, RTSP/RTP, ZIXI]
Memo :
0
Use reception devices that are compatible with
the respective transfer systems.
0
To use the “ZIXI” setting, a dedicated server is
needed separately.
9
UDP/TCP Settings
For specifying the settings that are enabled only
when [Type] is set to
“MPEG2-TS/UDP” or
“MPEG2-TS/TCP”.
Memo :
0
The settings cannot be changed during live
streaming.
o Destination Address
For setting details such as the host name and the
IP address of the live distribution destination.
* Enter
not more than 127 characters using single-
byte alphanumeric characters (a to z, 0 to 9),
single-byte hyphen [-], or dot [.].
o Destination Port
Enter the network port number of the live
distribution destination using an integer between 1
and 65535.
The default value is 6504.
9
RTSP/RTP Settings
For specifying the settings that are enabled only
when [Type] is set to
“RTSP/RTP”.
Memo :
0
The settings cannot be changed during live
streaming.
o Password
Changes
the password for RTSP authentication to
enable client access. The current password is
displayed. Enter a new password directly.
There is no default value (blank).
* Enter not more than 31 characters.
9
ZIXI Settings
For specifying the settings that are enabled only
when [Type] is set to
“ZIXI”.
Memo :
0
The settings cannot be changed during live
streaming.
o Destination Address
For setting details such as the host name and the
IP address of the live distribution destination.
* Enter
not more than 127 characters using single-
byte alphanumeric characters (a to z, 0 to 9),
single-byte hyphen [-], or dot [.].
o Destination Port
Enter the network port number of the live
distribution destination using an integer between 1
and 65535.
The default value is 2088.
o Stream ID
For setting the registered stream ID of the live
distribution destination.
The default value varies with the product model.
* Enter not more than 63 characters.
o Password
For setting the [Stream ID] password.
There is no default value (blank).
* Enter not more than 127 characters.
o Latency
For setting the latency mode.
[Setting Values: Medium, RLow]
Connection Setup
For configuring the network connection settings.
Configure
the settings by following the instructions
on the [Wizard] screen that is displayed according
to the type of adapter that is connected to the rear
[HOST] terminal.
You can store (Store), load (Load), or delete
(Delete) the settings you have specified on the
[Wizard] screen.
9
Wizard
A [Wizard]
screen appears according to the type of
adapter that is connected to the rear [HOST]
terminal.
Follow the instructions.
9
Load
Loads the settings on the
[Wizard] screen.
(A P170 [Reading the Connection Settings
File] )
9
Store
Saves the settings on the
[Wizard] screen.
(A P169 [Saving the Connection Settings File] )
9
Delete
Deletes the saved settings.
(A P171
[Deleting Connection Settings] )
123
Menu Display and Detailed Settings