User manual
Table Of Contents
- Introduction
- Preparations
- Shooting
- Basic Shooting Procedures
- Selecting System Definition, File Format and Video Format
- Zoom Operation
- Focus Operation
- Adjusting the Focusing by Face Detection
- Adjusting the Brightness
- Adjusting the Iris
- Setting the Gain
- Setting the Electronic Shutter
- Setting the ND Filter
- Adjusting the White Balance
- Adjusting the Camera Image
- Using the Image Stabilizer
- Audio Recording
- Monitoring Audio Sound During Recording Using a Headphone
- Time Code and User’s Bit
- Setting Time Code Generator
- Synchronizing Time Code on Another Camera
- Setting Zebra Pattern
- Setting Spot Meter
- Viewing Recorded Videos Immediately (Clip Review)
- Splitting the Clips Freely (Clip Cutter Trig)
- Dual Rec
- Backup Rec
- Special Recording
- Playback
- Menu Display and Detailed Settings
- Display/Status Screen
- Camera Features
- Connecting External Devices
- Others
*
When [Record Format]
B
[System] is set to “SD”,
only SD-SDI signals are output.
(A P109 [ System ] )
* To display the menu screen or display screen on
an external monitor, set [A/V Set] B [Video Set]
B [Display On TV] to “On”.
(A P105 [ Display On TV ] )
Connecting via SDI
0
Digital video signals, together with embedded
(superimposed) audio signals and time code
signals, are output for both the HD-SDI and SD-
SDI signals.
0
User’s bit output from the [HD/SD SDI] output
terminal is used as a flag to determine valid
video signals. Therefore, accurate values will
not be output.
Memo :
0
The sampling frequency for embedded
(superimposed) audio signals is 48 kHz. Time
code of the built-in time generator as well as
playback time code are also output.
Settings for SDI Down-Converted Output
0
You can select the method to “down convert” HD
video images to SD images during SD-SDI
output.
0
Set using [A/V Set] B [Video Set] B [SD
Aspect].
0
The available modes include “Side Cut”, “Letter”
(blackened at the top and bottom), and
“Squeeze” (full size, compressed at the left and
right).
(A P110 [ SD Aspect ] )
Memo :
0
When [Record Format]
B
[System] is set to “SD”,
and [SD Aspect] is set to “4:3”, this item cannot be
selected.
(A P109 [ System ] )
Connecting the
Headphone
0
Audio output from the [x] terminal can be
selected using [A/V Set] B [Monitor] or the
[MONITOR] selection switch on the camera
recorder.
(A P107 [ Monitor ] )
0
The different combinations of settings that are
output from the [x] terminal and monitor
speaker are as follows.
[MONITOR]
Switch
Settings
[Monitor]
Settings
[x]
terminal
Speaker *
L R
[CH1] - CH1 CH1
[BOTH] [Mix] CH1+CH2 CH1+CH2
[Stereo] CH1 CH2
[CH2] - CH2 CH2
* Audio is output from the speaker only in Media
mode. Does not output in the Camera mode.
.
AUX
INPUT2
INPUT1
D
E
V
IC
E
A
V
A
BATT.RELEASE
POWER
/CHG
B
H
D
M
I
R
E
M
O
T
E
D
C
H
D
/S
D
S
D
I
REC
AUX
POWER
/CHG
Memo :
0
If both CH1 and CH2 are built-in microphones,
stereo sound is output from the [x] terminal
regardless of the [MONITOR] switch setting and
[Monitor] setting.
131
Connecting External Devices