User manual
Table Of Contents
- Introduction
- Preparations
- Shooting
- Basic Shooting Procedures
- Selecting System Definition, File Format and Video Format
- Zoom Operation
- Focus Operation
- Adjusting the Focusing by Face Detection
- Adjusting the Brightness
- Adjusting the Iris
- Setting the Gain
- Setting the Electronic Shutter
- Setting the ND Filter
- Adjusting the White Balance
- Adjusting the Camera Image
- Using the Image Stabilizer
- Audio Recording
- Monitoring Audio Sound During Recording Using a Headphone
- Time Code and User’s Bit
- Setting Time Code Generator
- Synchronizing Time Code on Another Camera
- Setting Zebra Pattern
- Setting Spot Meter
- Viewing Recorded Videos Immediately (Clip Review)
- Splitting the Clips Freely (Clip Cutter Trig)
- Dual Rec
- Backup Rec
- Special Recording
- Playback
- Menu Display and Detailed Settings
- Display/Status Screen
- Camera Features
- Connecting External Devices
- Others
Managing/Editing Clips on
a PC
Loading Clips to the PC (USB
Connection Mode)
0
You can load clips to a PC by connecting the
camera recorder to the PC via the USB port.
Doing so enables clips stored in the SD card to
be managed and edited on the PC.
0
Files on the SD card can be managed/edited on
the connected PC in this mode only for USB
mass storage class devices that are recognized
by the said PC as a peripheral drive.
Memo :
0
Files cannot be written to the SD card.
0
Make sure to manage/edit files recorded in the
MP4 file format using the (JVC ProHD Clip
Manager) PC application software in the
supplied disc.
0
For details on how to install the application
software, refer to the [User's Guide] of the [JVC
ProHD Clip Manager] inside the supplied disc.
1
Connect the camera recorder to the PC
using a USB cable.
A confirmation message “Change to USB
Mode?” to enable the USB connection appears.
.
AUX
INPUT2
INPUT1
D
E
V
IC
E
A
V
A
BATT.RE L EASE
POWER
/CHG
B
H
D
M
I
R
E
M
O
T
E
D
C
H
D
/S
D
S
D
I
REC
AV
DEVICE
PC
2
Select [Change] using the cross-shaped
button (JK), and press the Set button (R).
The camera recorder switches to USB mode.
.
2
Memo :
0
If recording is in progress, the “Change to USB
Mode?” message appears after recording
stops.
0
If playback is in progress, the camera recorder
switches to USB mode after the file closes
automatically, such as when playback stops.
Disconnecting
0
Disable the connection on the PC, then remove
the USB cable from the camera recorder.
0
Doing so exits the USB mode and switches the
camera recorder to Camera mode.
Memo :
0
The procedure for disabling the USB connection
varies according to the PC in use. For details,
refer to the instruction manual of the PC.
129
Connecting External Devices