User manual
Table Of Contents
- Introduction
- Preparations
- Shooting
- Basic Shooting Procedures
- Selecting System Definition, File Format and Video Format
- Zoom Operation
- Focus Operation
- Adjusting the Focusing by Face Detection
- Adjusting the Brightness
- Adjusting the Iris
- Setting the Gain
- Setting the Electronic Shutter
- Setting the ND Filter
- Adjusting the White Balance
- Adjusting the Camera Image
- Using the Image Stabilizer
- Audio Recording
- Monitoring Audio Sound During Recording Using a Headphone
- Time Code and User’s Bit
- Setting Time Code Generator
- Synchronizing Time Code on Another Camera
- Setting Zebra Pattern
- Setting Spot Meter
- Viewing Recorded Videos Immediately (Clip Review)
- Splitting the Clips Freely (Clip Cutter Trig)
- Dual Rec
- Backup Rec
- Special Recording
- Playback
- Menu Display and Detailed Settings
- Display/Status Screen
- Camera Features
- Connecting External Devices
- Others
Y
Media Status
---- : No card found in the selected
slot
STBY : Recording standby
RREC : Recording
REVIEW : Clip Review
(A P70 [Viewing Recorded Videos Immediately
(Clip Review)] )
STBY P : Pre Rec recording standby
(A P75 [Pre Rec] )
RRECP : Pre Rec recording
(A P75 [Pre Rec] )
STBY C : Clip Continuous Rec recording
standby
(A P76 [Clip Continuous Rec] )
R
REC
C
: Clip Continuous Rec recording
(A P76 [Clip Continuous Rec] )
STBY
C
(displayed in
yellow)
: Clip Continuous Rec recording
pause
(A P76 [Clip Continuous Rec] )
STBY N : Interval Rec recording standby
(A P78 [Interval Rec] )
STBYN
(displayed in
red)
: Interval recording pause
RRECN : Interval Rec recording
(A P78 [Interval Rec] )
STBY M : Frame Rec recording standby
(A P77 [Frame Rec] )
RRECM : Frame Rec recording
(A P77 [Frame Rec] )
STBYM
(displayed in
yellow)
: Frame Rec recording pause
(A P77 [Frame Rec] )
STOP : Unable to record to the card in
the slot
P.OFF : Power OFF
Z
Dual Rec/Backup Rec Display
“DUAL” is displayed in the Dual Rec mode and
“BACKUP” is displayed in the Backup Rec
mode.
(A P111 [ Slot Mode ] )
Memo :
0
This item is not displayed when [Slot Mode] is
set to “Series”.
0
This item is not displayed when [Main Menu] B
[LCD/VF] B [Display Settings] B [Media
Remain] is set to “Off”. However, warnings will
be displayed.
(A P104 [ Media Remain ] )
0
Displayed in the Display 0 and Display 1 screens
during warnings only. (When the remaining time
is shorter than 3 minutes)
120
Display/Status Screen