User manual
Table Of Contents
- Introduction
- Preparations
- Shooting
- Basic Shooting Procedures
- Selecting System Definition, File Format and Video Format
- Zoom Operation
- Focus Operation
- Adjusting the Focusing by Face Detection
- Adjusting the Brightness
- Adjusting the Iris
- Setting the Gain
- Setting the Electronic Shutter
- Setting the ND Filter
- Adjusting the White Balance
- Adjusting the Camera Image
- Using the Image Stabilizer
- Audio Recording
- Monitoring Audio Sound During Recording Using a Headphone
- Time Code and User’s Bit
- Setting Time Code Generator
- Setting the User’s Bit
- Setting Zebra Pattern
- Viewing Recorded Videos Immediately (Clip Review)
- Recording Simultaneously at Two Different Definitions
- Series Rec
- Dual Rec
- Backup Rec
- Special Recording
- Splitting the Clips Freely (Clip Cutter Trig)
- Playback
- Menu Display and Detailed Settings
- Display/Status Screen
- Camera Features
- Connecting External Devices
- Connecting to the Network
- Functions of Network Connection
- Preparing Network Connection
- Importing Metadata
- Uploading a Recorded Video Clip
- Connecting from a Web Browser
- Editing Metadata
- Uploading a Recording Clip via a Web Browser
- View Remote Feature
- Camera Control Function
- Configuring Settings via a Browser
- Managing the Network Connection Settings File
- Performing Live Streaming
- Others
Camera Setup for Network Connection
1
Connect an appropriate adapter according
to the intended use to the
[HOST] terminal
at the side terminal section of the camera
recorder.
The following adapters can be connected.
0
Wireless LAN adapter
0
Ethernet adapter
0
Cellular adapter
.
Connect an appropriate adapter
Memo :
0
Only a network connection adapter can be
connected to the
[HOST] terminal.
0
Connect
or disconnect an adapter only after you
have turned off the power of the camera
recorder.
0
You can find the latest information on the
compatible adapters at the product page of our
website.
0
Two types of network coverage (WAN and LAN)
are available for each application.
2
Enable the network connection.
Set [Main Menu] B [System
] B [Network] to
“On”.
3
Configure the connection settings.
0
Select [Main
Menu] B [System] B [Network]/
[Settings] B [Connection Setup] B [Wizard]
and press the Set button (R).
0
A wizard screen appears according to the
type of adapter connected. Follow the
instructions
on the screen to perform setting.
(A P143 [Connecting via Wireless LAN] )
(A P145 [Connecting via Wired LAN] )
(A P145 [Connecting via Cellular Adapter] )
Connecting via Wireless LAN
Connection via Access Point
1
Perform setting on the camera recorder,
and start up the
[Wizard] screen.
(A P
143 [Camera Setup for Network
Connection] )
2
[Wireless LAN] appears on the [Wizard]
screen.
.
Back Next
Wireless LAN
Available Adapter
3
Press the I button to display the
[Select
Connection Type] screen.
Select “Connect with Access Point”.
Follow the screen instructions to complete
setting. Perform setting for the following.
0
Mode of connection
0
Method of setting
* SSID, type of encryption, Passphrase, and
IP Address setting (“DHCP
” or “Manual”) in
cases other than WPS
.
3
Back Next
Connect with Access Point
P2P
Select Connection Type
4
Setting is complete.
After setting is complete, you can access the
camera recorder via a web browser.
(A P150 [Connecting from a Web Browser
K] )
Preparing Network Connection K
143
Connecting to the Network
K