User manual

Int. Mic Wind Cut
For
selecting whether to cut the low frequencies of
the audio input signals (low-cut) from the built-in
microphone. Set this item to “On” to reduce wind
noise from the microphone.
[Setting Values: On, ROff]
Memo :
0
This item is enabled in the following cases.
0
When the [CH1] or [CH2] selection switch is
set to “INT”. O
0
[CH1 INT
] is set to “Int. Mic L” or [CH2 INT] is
set to “Int. Mic R”.
(A P110
[ CH1 INT ] )
(A P110 [ CH2 INT ] )
Int. Mic Stereo Enhancer
For setting the enhancement level of the stereo
effect of the built-in microphone.
0
On:
Enhances the stereo effect.
0
Off:
Does not enhance the stereo effect.
[Setting Values: On, ROff]
Memo :
0
This item is enabled in the following cases.
0
Both [CH1] and [CH2] selection switches are
set to “INT”. O
0
[CH1 INT] is set to
“Int. Mic L” and [CH2
INT] is set to “Int. Mic R”.
(A P110
[ CH1 INT ] )
(A P110 [ CH2 INT ] )
Monitor
For setting the audio output from the [x] jack or the
speaker.
0
CH1:
Outputs only the audio input from
[CH1].
0
CH2:
Outputs only the audio input from [CH2].
0
Mix:
Generates
a mixed audio output from [CH1] and
[CH2].
0
Stereo:
Outputs audio from [
CH1] to L and audio from
[CH2] to R.
[Setting Values: CH1, CH2, Mix, RStereo]
Memo :
0
If both
[CH1] and [CH2] are input signals of the
built-in microphone, “Mix” cannot be selected for
the output from the [x] jack.
0
“Stereo” cannot
be selected for speaker output.
Alarm Level
For selecting whether to turn on the warning tone
as well as setting the volume.
The warning tone is output from the monitor
speaker or [x] terminal.
[Setting Values: High, Low, ROff]
Test Tone
For specifying whether to output the audio test
signals (1 kHz) during color bar output.
[Setting Values: On, ROff]
Audio On FULL AUTO
For setting whether to enable Auto for audio when
Full
Auto is enabled using the [FULL AUTO] button.
0
SW Set:
The audio recording mode follows the settings
below.
0
When the handle unit is connected: Follows
the [CH1 AUTO/MANUAL]/[CH2 AUTO/
MANUAL] selection switch setting.
0
When the handle unit is not connected:
Follows the MENU setting (AUTO/MANUAL
in the audio level setting).
0
Auto:
Sets audio recording mode to the forced auto
mode.
[Setting Values: SW Set, RAuto]
112
A/V Set Menu
Menu Display and Detailed Settings