INSTRUCTIONS(BASIC)

V
Time Code (I)/User’s Bit (J) Display
0
Displays the time code (hour: minute:
second: frame) or user’s bit data.
0
Example of time code display:
Display Screen
.
00:00:00:00
*
* Colon (:) denotes non-drop frames and dot
(.) denotes drop frames.
Enlarged Display
[NDF] is displayed to the right of
[TC] in the
case of non-drop frames and [DF] in the case
of drop frames.
.
00H 00M 00S 00F
NDF
R-RUN
0
Example of user’s bit display:
Display Screen
.
FF EE DD 20
Memo :
0
Use the
[TC DISPLAY] switch to toggle between
the time code display and user’s bit display.
W
Time Code Lock Indicator
When the built-in time code generator is
synchronized to the external time code data
input during the synchronization of time code
with another camera recorder, Z lights up.
When in the enlarged display mode, [EXTZ] is
shown in the TC mode display.
X
SDI/HDMI Record Trigger
STBY B : When [SDI Rec Trigger] is set to
“Type-A
” or “Type-B”, or [HDMI Rec
Trigger] is set to “On” and recording
is stopped
REC B : When [SDI Rec Trigger] is set to
“Type-A” or “Type-B”, or [HDMI Rec
Trigger] is set to “On” and recording
is in progress
Y
GPS Mark u v
When [System] B [GPS] is set to “On”, the
signal reception status is displayed.
Memo :
0
The display changes according to the signal
reception sensitivity. If signals cannot be
received, the H mark appears in yellow
regardless of the [LCD/VF] B [Display On/Off
]
B [GPS] setting.
0
This item is not displayed when
[GPS] is set to
“Off”.
Z
Media Status
---- :
A card is not detected in the
selected slot, and [Tally
System] is also not set to
“Studio”
STBY : Recording standby
RREC : Recording
REVIEW : Clip Review
STOP : Unable to record to the card in
the slot
P.OFF : Power OFF
CALL : Receiving call signals from an
external device, such as a
remote control unit
PGM : Receiving program signals
from an external device, such
as a remote control unit
PVW : Receiving preview signals
from an external device, such
as a remote control unit
Display Screen in Camera Mode
37
Others