INSTRUCTIONS(BASIC)

Connecting to the
Network
Connecting to Network via [LAN]
Terminal
1
Configure the connection settings with
[LAN Wizard]
.
0
Select [
Network] B [Connection Setup] B
[LAN Wizard] and configure the settings
according to the instructions on the screen.
Perform setting for the following.
0
IP address setting (DHCP or manual)
0
IP Address
0
Subnet mask
0
Default gateway
0
DNS Server
Memo :
0
When an
address is manually assigned in a NAT
environment, it is also necessary to set the
default gateway correctly besides conversion of
the address at the router’s end in order to
perform operations such as access to the
Internet from an external network via the router.
2
Setting is complete.
After setting is complete, you can access the
camera recorder via a web browser.
Connecting to Network via Built-in
Wireless LAN u v
or [
HOST]
Terminal (USB)
u v
1
Set the network connection for USB/
Wireless LAN to “On”.
0
Select [Network]
B [Connection Setup] B
[USB/Int. WLAN] and configure the setting to
“On”.
2
Configure the connection settings with
[
Wizard]
.
0
Select [Network] B [Connection Setup]
B
[Wizard] and configure the settings
according to the instructions on the screen.
w x
1
Configure the connection settings with
[USB Wizard]
.
0
Select [Network] B [Connection Setup]
B
[USB Wizard] and configure the settings
according to the instructions on the screen.
Configure the settings for the following
according to the type of connection.
o
USB wireless LAN connection/built-in
wireless LAN connection u v
0
Mode of connection
0
Configuration method
* For P2P connections, it is necessary to
configure the [Passphrase] according to
the steps below after the above settings
are configured.
A
Set the camera recorder to the Camera
mode, and display the status screen
([USB/Int. WLAN] screen
u v or
[USB] screen w x).
0
Press the [STATUS/SET
] button on the
camera recorder to display the status
screen.
Press the cross-shaped button (H I) to
display the [USB/Int. WLAN] screen u
v or [USB] screen w x.
0
Check to ensure that the [Passphrase
]
and
[Passphrase] that you have set in the
wizard are displayed.
B
Select an SSID from the list of access
points (smartphone, tablet terminal, PC,
etc.) and enter a passphrase.
0
Display the list of access points in the
wireless connection settings of the
smartphone, tablet terminal, or PC, and
select “HC900-****”. (**** are numbers
that vary with the device used.)
0
After the password confirmation screen
appears, enter the [Passphrase]
displayed on
the [USB/Int. WLAN] screen
u v or [USB] screen w x.
Connecting to the Network
29
Network