INSTRUCTIONS(BASIC)

4
Press the [STATUS/SET] button (R) after
confirming the exit screen.
The [Date/Time] screen appears.
0
For U models
.
0
For E models
.
5
Set the time zone and date/time.
A
Move the cursor with the cross-shaped button
(HI) and select the setting item.
B
Change the values with the cross-shaped
button (JK).
6
Press the [STATUS/SET] button (R) after
setting is complete.
The clock is set to 0 seconds of the input date/
time.
Memo :
0
The configured
date/time data can be displayed
on the LCD monitor and viewfinder and be
recorded to the SD card.
0
The value of the year can be set in the range of
“2000” to “2099”.
0
The configured date/time data is saved in the
built-in battery even if the power is turned off.
0
If the date/time data is no longer retained, the
built-in battery is dead. For replacement of the
built-in battery, please contact the local dealers
in your area.
Adjusting the Back Focus
When the lens is attached for the first time, adjust
the back focus of the lens if the focus is not clear
when it is zoomed to the telephoto or wide-angle
end.
0
The Siemens Star Chart is most suitable as the
subject.
.
Siemens Star Chart
1
Place an object at approximately 3 m away
from the camera recorder.
2
Open up the iris.
3
Set the lens to the telephoto end.
4
Turn the focusing ring to adjust the focus.
5
Set the lens to the wide-angle end.
6
Loosen the F.B. locking screw of the lens
and turn the back focus adjustment ring to
adjust the focus.
7
Repeat the steps from 3 to 6 to adjust the
focus at both ends of the zoom.
8
After determining the position of the back
focus adjustment ring, tighten the F.B.
locking screw.
Memo :
0
For details, please refer to the
“INSTRUCTIONS” of the lens.
Initial Settings
21
Preparations