INSTRUCTIONS(BASIC)

Power Supply
To use this camera recorder, you can attach a
battery pack or connect an AC adapter to it.
Caution :
0
Set the [
POWER ON/OFF] switch to “OFF”
before changing the power supply that operates
this camera recorder.
0
Use the camera recorder and peripheral
equipments within the rated output of the AC
adapter.
0
To connect other peripheral equipment, do so
under the following conditions.
0
Keep the total power consumption of the
peripheral equipments under 35 W when
using the recommended battery.
0
Keep the total power consumption of the
peripheral equipments under 65 W when
using Tandem 150 (recommended AC
adapter).
0
Keep the total power consumption of the
peripheral equipments under 50 W when
using AC-100 (recommended AC adapter).
0
The power
consumption of the [LIGHT] terminal
is below 50 W. Keep the total power
consumption of the peripheral equipments
excluding the [LIGHT] terminal under 35 W
when using the [LIGHT] terminal.
If the total power consumption of the peripheral
equipments exceeds the rating, the power to the
[LIGHT], [12V y 1.8A] DC OUT and [12V y
0.5A] DC OUT (LAN) terminals is automatically
cut off. This is not a malfunction. Use peripheral
equipments with lower power consumption then
turn on the power of this camera recorder again.
0
If the voltage of the
[DC INPUT
] becomes 12 V
or less, the USB adapter connected to the
[HOST] terminal cannot be used. Check the
power supply and the peripheral equipments,
and turn on the power of this camera recorder
again.
Using AC Power (DC IN Power)
Use the AC adapter (sold separately) to operate
the camera recorder with AC power.
Recommended AC Adapter
U model : Tandem 150 (Anton/Bauer)
E model
:
AC-100 (IDX)
Memo :
0
For the type of AC adapter to be attached on a
battery
mount,
check the method of attachment
in [Using a Battery Pack] (A P 18).
1
Connect the DC cable of the AC adapter to
the [DC INPUT] terminal of the camera
recorder.
Check
that the power of this unit and that of the
AC adapter are both set to “OFF
”, followed by
connecting according to the diagram.
.
2
Turn on the power of the AC adapter,
followed by setting the [POWER ON/OFF]
switch of this unit to “ON”.
Power will be supplied to the camera recorder.
Caution :
0
Do not insert or remove the DC cable during
recording.
0
Do not use power supply of high voltage
fluctuation, containing noise such as ripple, or
with insufficient capacity.
Power Supply
17
Preparations