User manual

Expanded Focus Function
You can magnify the preferred area by pressing the
user button assigned with “Expanded Focus”;
doing so enables precise focus to be established
easily.
1
When
the user button that is assigned with
“Expanded Focus” is pressed.
0
The center
area of the screen is enlarged for
the first time.
0
For subsequent operation of the button, the
area at which the operation was last
performed will be enlarged.
.
2
Use the cross-shaped button (JKH I) to
magnify the preferred area.
0
The portion that is being magnified is
displayed at the lower right corner of the
screen.
3
Press the [CANCEL/RESET] button to
cancel the setting.
Memo :
0
The display of the enlarged screen is dot by dot
equivalent.
0
To set the operation when the button is pressed,
go to [Camera Function] B [User Switch Set] B
[Expanded Focus].
(A P116 [ Expanded Focus ] )
0
Pressing and holding the Set button (
R) resets
the position of magnification.
0
This function can be used together with the
Focus Assist function.
0
Magnifying an image does not alter the size of
the recorded image.
0
If the
“Expanded Focus” function is assigned to
the cross-shaped button, the cross-shaped
button cannot be used as user button while the
area is being magnified.
0
This function is unavailable when [System]
B
[Record Set] B [Record Format] B [System] is
set to “SD”.
0
When the display screen is turned off, the
magnified
area
at the bottom right of the screen
will not be displayed.
Adjusting the Brightness
Adjust the brightness using Iris, Gain, Shutter
speed and ND filter according to the brightness of
the object.
Adjusting
the
Brightness Automatically:
Automatic Brightness Adjustment (AE)
Mode
Iris, Gain, Shutter speed and ND filter are
automatically adjusted
according to the brightness
of the object to maintain optimum brightness.
To set only the Gain, Iris and Shutter to Auto mode,
set the Full Auto mode to off before setting each
item to the automatic adjustment mode using the
user button assigned with “Full Auto”.
1
Set Gain, Iris and Shutter to Auto mode.
0
[Adjusting the Iris] (A P 61)
0
[Setting the Gain] (
A P 62
)
0
[Setting the Electronic Shutter] (A P 63)
2
Set the target level (brighter/darker) to
maintain optimum brightness during
automatic adjustment.
0
Press the user button assigned with
“AE
Level
” and when the “AE±” indication turns
white operate the cross-shaped button (JK)
to set the target level.
0
This can
be configured in [Camera Function]
B [AE Level].
.
100min
50min
282min
1
/60
F2.8
AE
±0
ND1
/64
12 :34 :56
ISO
102400
00: 00:00.00
1080 /30p
SDI IN
ITU709
COMPRESS
5 . 6 f t
B 5600
K
60
Focus Operation
Shooting