User manual

CH1/2 DRC..., CH3/4 DRC...
For configuring the individual parameters of DRC
(Dynamic Range Compression).
(A P74 [References on DRC (Dynamic Range
Compressor) and Limiter] )
9
Threshold Level
For configuring
the threshold of DRC for CH1/2 and
CH3/4.
[Setting Values: R -6dBFS, -9dBFS, -12dBFS,
-15dBFS, -17dBFS, Off]
9
Attack Time
For configuring
the time before DRC for CH1/2 and
CH3/4 operates.
[Setting Values: Fast, RMiddle, Slow]
9
Decay Time
For configuring
the time before the DRC operation
for CH1/2 and CH3/4 is canceled.
[Setting Values: Fast, RMiddle, Slow]
9
Mode
For configuring whether DRC for each channel
operates independently or in tandem with each
other.
([CH1] and [CH2], [CH3] and [CH4])
Select “Linked” to link or “Separate
” to separate.
[Setting Values: Linked, RSeparate]
Limitter...
9
CH1(/2/3/4)
For configuring
whether to enable limiter operation
for each channel.
0
On:
Enables limiter operation.
0
Off:
Disables limiter operation.
0
AUTO/MANUAL SW Set:
Operates according to the [AUDIO INPUT
MANUAL/AUTO] selection switch.
Operation is “On
” in the AUTO mode and “Off”
in the MANUAL mode.
[Setting Values: On, Off, RAUTO/MANUAL SW
Set]
Mic Wind Cut...
9
CH1(/2/3/4)
For configuring whether to cut the low-frequency
range of
the audio signal when “FRONT” or “REAR”
is selected for [AUDIO INPUT] of each channel and
“MIC” or “MIC+48V” is selected for [AUDIO INPUT
1/2] at the back of the camera.
Set this item to reduce wind noise from the
microphone.
[Setting Values: On, ROff]
Memo :
0
When [Mic Wind Cut] is set to “On”, a icon
is displayed on the status screen (audio input)
while the function is operating.
Test Tone
For specifying whether to output the audio test
signals (1 kHz) during color bar output.
[Setting Values: On, ROff]
AUDIO OUT Ch.
For setting the channel to output to the [AUDIO
OUT] terminal.
0
CH3/4:
Outputs the audio of [CH3] and [CH4].
0
CH1/2:
Outputs the audio of [CH1
] and [CH2].
0
MONI SEL SW Set:
Outputs according to the [MONI SELECT]
switch setting.
[Setting Values: CH3/4, CH1/2, RMONI SEL SW
Set]
AUDIO OUT Ref.
For configuring the reference output level of the
[AUDIO OUT] terminal.
[Setting Values: +4dB, R 0dB, -3dB]
140
A/V Set Menu
Menu Display and Detailed Settings