User manual

9
Rec Trigger
For configuring whether to superimpose trigger
signals on the [
HDMI] out terminal in tandem with
the [REC] button.
If “On” is specified, it is possible to record on a
device equipped with HDMI record trigger in
tandem with the operation of the [REC] button.
When a compatible device is connected,
recording/stop control signals are output in tandem
with the operation of the [REC] button.
The HDMI record trigger output status to the
connected device is indicated by REC B/STBY B
on the display screen.
[Setting Values: On, ROff]
Memo :
0
Even if REC B/STBY B is displayed on the
display screen, the compatible device may not
necessarily be recording.
0
This item can be configured when [HDMI OUT]
is set to a value other than
“Off”, and [Rec
Mode] is set to “Normal”, “Pre Rec” or “Clip
Continuous”.
0
Set to “Off” if connecting to a device that does
not support record trigger.
9
TC
For setting whether to superimpose time code to
the [HDMI] terminal.
[Setting Values: On, ROff]
Memo :
0
This item can be configured when [HDMI OUT]
is set to a setting other than
“Off”.
0
Set to “Off” if connecting to a device that does
not support HDMI TC.
VIDEO OUT
For configuring video output from the [VIDEO
OUT] terminal.
[Setting Values: On,
ROff]
9
Character (VIDEO OUT)
For configuring whether to show the display and
menu on the [VIDEO OUT]
terminal.
[Setting Values: On, ROff]
SD Aspect
For setting the style of displaying images with a
16:9 aspect ratio on a 4:3 aspect ratio screen.
0
Side Cut:
Displays image with the left and right sides cut
off.
0
Letter:
Displays as a wide image with the top and
bottom blackened.
0
Squeeze:
Displays image that is squeezed horizontally.
[Setting Values: Side Cut, Letter, RSqueeze]
Memo :
0
When [Record Format] B [System] is set to
“SD”, and [Record Format] B [SD Aspect] is set
to “4:3”, “---” is displayed and selection is
disabled.
(A
P160 [ System ] )
0
[System]
B [Record Set]
B [Record Format] B
[System] is set to “SD”, “Squeeze” and “Letter”
can be selected.
SD Set Up
For selecting whether to add a setup signal to the
video signal
output from the [VIDEO OUT] terminal.
Setup signals are added when “7.5%” is selected.
[Setting Values: 7.5%, R0.0%]
Memo :
0
Depending on the menu settings of the camera
recorder and the condition of the cable
connected to it, the setup signal setting may be
fixed at
“0.0%”. “0.0%” is displayed in gray in this
case.
0
When [System] B [Record Set] B [Record
Format]B[Frame Rate] is set to “50p” or “50i”,
“---” is displayed and selection is disabled.
A/V Set Menu
137
Menu Display and Detailed Settings