INSTRUCTIONS

9
Rec Trigger
For configuring whether to superimpose trigger
signals on the [
HDMI] out terminal in tandem with
the [REC] button.
If “On” is specified, it is possible to record on a
device equipped with HDMI record trigger in
tandem with the operation of the [REC] button.
When a compatible device is connected,
recording/stop control signals are output in tandem
with the operation of the [REC] button.
The HDMI record trigger output status to the
connected device is indicated by REC B/STBY B
on the display screen.
[Setting Values: On, ROff]
Memo :
0
Even if REC B/STBY B is displayed on the
display screen, the compatible device may not
necessarily be recording.
0
This item can be configured when [HDMI OUT]
is set to a value other than
“Off”, and [Rec
Mode] is set to “Normal”, “Pre Rec” or “Clip
Continuous”.
0
Set to “Off” if connecting to a device that does
not support record trigger.
9
TC
For setting whether to superimpose time code to
the [HDMI] terminal.
[Setting Values: On, ROff]
Memo :
0
This item can be configured when [HDMI OUT]
is set to a setting other than
“Off”.
0
Set to “Off” if connecting to a device that does
not support HDMI TC.
Audio Set Item
Input1 Mic Ref.
For setting the reference input level when the
[INPUT1] selection switch is set to “MIC” or “MIC
+48V”.
[Setting Values: -62dB, -56dB,
R-50dB, -44dB,
-38dB, -32dB]
Input2 Mic Ref.
For setting the reference input level when the
[INPUT2] selection switch is set to “MIC” or “MIC
+48V”.
[Setting Values: -62dB, -56dB,
R-50dB, -44dB,
-38dB, -32dB]
Int. Mic Gain
For setting
the sensitivity of the built-in microphone.
[Setting Values: 12 dB, 6 dB, R0dB]
AUX Gain
For setting the sensitivity of the [AUX]
terminal
input.
[Setting Values: 12 dB, 6 dB, R0dB]
Ref. Level
For setting the recording reference level. (Applies
to both [CH1/CH2]
.)
[Setting Values: -12dB, -18dB, R-20dB]
Limiter
For setting the limiter operation.
0
-9dBFS:
Sets “-9dBFS” to the maximum recording level.
0
-6dBFS:
Sets “-6dBFS” to the maximum recording level.
0
Off:
Depending on the settings of the [CH1/CH2
AUTO/MANUAL] selection switches, the
operation may be different as described below.
0
The limiter does not function when
“MANUAL” is set.
0
The limiter functions at -6dBFS when “AUTO”
is set.
[Setting Values: -9dBFS, R-6dBFS, Off]
132
A/V Set Menu
Menu Display and Detailed Settings