INSTRUCTIONS(BASIC)

d
SDI/HDMI Record Trigger
STBY B
:
When [A/V Set] B [Video Set
] B
[SDI OUT] B [Rec Trigger] is set to
“Type-A” or “Type-B”, or [HDMI
OUT] B [Rec Trigger] is set to “On”
and recording is stopped
REC B
:
When [A/V Set] B [Video Set] B
[SDI OUT] B [Rec Trigger] is set to
“Type-A” or “Type-B”, or [HDMI
OUT] B [Rec Trigger] is set to “On”
and recording is in progress
e
GPS Mark A L
When [System] B [GPS] is set to “On”, the
signal reception status is displayed.
Memo :
0
The display changes according to the signal
reception sensitivity. If signals cannot be
received, the H mark appears in yellow
regardless of the [
LCD/VF] B [Display On/Off]
B [GPS] setting.
0
This item is not displayed when
[
GPS] is set to
“Off”.
f
Media Status
---- :
A card is not detected in the
selected slot, and [Tally Lamp]
is configured to a setting other
than “External” or [STATUS
LED] is configured to a setting
other than “External”
STBY : Recording standby
RREC
: Recording
REVIEW : Clip Review
STBY O
: Pre Rec recording standby
RRECO
: Pre Rec recording
STBY L
: Clip Continuous Rec recording
standby
RRECL
: Clip Continuous Rec recording
STBYL
(displayed in
yellow)
: Clip Continuous Rec recording
pause
STBY N
: Interval Rec recording standby
STBYN
(displayed in
red)
: Interval recording pause
RRECN
: Interval Rec recording
STBY M
: Frame Rec recording standby
RRECM
: Frame Rec recording
STBYM
(displayed in
yellow)
: Frame Rec recording pause
STOP : Unable to record to the card in
the slot
P.OFF
:
Power OFF
Q
: During clip cutter recording
(displayed for 3 seconds)
PGM : Receiving program signals
from an external device, such
as a remote control unit
PVW : Receiving preview signals
from an external device, such
as a remote control unit
g
Live streaming mark
When [Network] B [Live Streaming] B [Live
Streaming] is set to “On”, the distribution status
is displayed.
Icon Status
.
(Red)
Distribution in progress (good
connection quality)
.
(Red)
Distribution in progress (poor
connection quality)
.
(Yellow)
Waiting for connection
(RTSP/RTP only), connection
failed
h
High-Speed Frame Rate
0
When [System] B [Record Set]
B [Record
Format] B [System] is configured to “High-
Speed”, the setting value for [WFrame Rate]
is displayed.
i
OK Mark
Displayed
when
OK mark has been appended.
j
Recording Format
Displays the recording format.
Memo :
0
The resolution, frame rate and bit rate can be
viewed on the status screen.
k
Event/Warning Display Area
Displays error messages.
Display Screen in Camera Mode
39
Others