INSTRUCTIONS(BASIC)

d
SDI/HDMI Record Trigger
STBY B : When [A/V Set]
B [Video Set] B
[SDI OUT] B [Rec Trigger] is set to
“Type-A” or “Type-B”, or [HDMI
OUT] B [Rec Trigger] is set to “On”
and recording is stopped
REC B : When [A/V Set] B [Video Set] B
[SDI OUT] B [Rec Trigger] is set to
“Type-A” or “Type-B”, or [HDMI
OUT] B [Rec Trigger] is set to “On”
and recording is in progress
e
GPS Mark AL
When [System] B [GPS] is set to “On”, the
signal reception status is displayed.
Memo :
0
The display changes according to the signal
reception sensitivity. If signals cannot be
received, the H mark appears in yellow
regardless of the [LCD/VF]
B [Display On/Off]
B [GPS] setting.
0
This item is not displayed when
[GPS
] is set to
“Off”.
f
Media Status
---- : A card is not detected in the
selected slot, and [Tally
Lamp] is also not set to
“External”
STBY
: Recording standby
RREC : Recording
REVIEW : Clip Review
STBY O : Pre Rec recording standby
RRECO : Pre Rec recording
STBY L : Clip Continuous Rec recording
standby
RRECL : Clip Continuous Rec recording
STBYL
(displayed in
yellow)
: Clip Continuous Rec recording
pause
STBY N : Interval Rec recording standby
STBYN
(displayed in
red)
: Interval recording pause
RRECN : Interval Rec recording
STBY M : Frame Rec recording standby
RRECM : Frame Rec recording
STBYM
(displayed in
yellow)
: Frame Rec recording pause
STOP : Unable to record to the card in
the slot
P.OFF : Power OFF
Q
:
During clip cutter recording
(displayed for 3 seconds)
CALL : Receiving call signals from an
external device, such as a
remote control unit
PGM : Receiving program signals
from an external device, such
as a remote control unit
PVW : Receiving preview signals
from an external device, such
as a remote control unit
g
Live streaming mark
When [Network] B [Live Streaming] B [Live
Streaming] is set to “On”, the distribution status
is displayed.
Icon Status
.
(Red)
Distribution in progress (good
connection quality)
.
(Red)
Distribution in progress (poor
connection quality)
.
(Yellow)
Waiting for connection
(RTSP/RTP only), connection
failed
h
High-Speed Frame Rate
0
When [System] B [Record Set]
B [Record
Format] B [System] is configured to “High-
Speed”, the setting value for [WFrame Rate]
is displayed.
i
OK Mark
Displayed
when OK
mark has been appended.
j
Recording Format
Displays the recording format.
Memo :
0
The resolution, frame rate and bit rate can be
viewed on the status screen.
Display Screen in Camera Mode
39
Others