INSTRUCTIONS

Time Code Operation Mode
Set the time code operation in [TC/UB] B [TC
Generator].
(A
P125 [ TC Generator ] )
Setting Description
Free
Run(NTP)
Time code information can be
synchronized with the time
information
obtained from the NTP
server.
Free
Run(GPS)
L
Time code information can be
synchronized with the date/time
information acquired from the
GPS.
Free Run
(Ext)
This mode synchronizes another
camera recorder connected to the
[TC] terminal. The time code
operates in the run mode at all
times regardless of the recording
status.
It continues to run even when the
power of the camera recorder is
turned off.
Free Run The time code operates in the run
mode
at all times regardless of the
recording status.
It continues to run even when the
power of the camera recorder is
turned off.
Rec Run The time code operates in the run
mode during recording. It
continues
to run in the order of the
recorded clips as long as the SD
card is not replaced. If the SD card
is removed and recording is made
on another card, time code will be
recorded on the new card from
where it was left off in the previous
card.
Regen The time code operates in the run
mode during recording. When the
SD card is replaced, the last time
code recorded on the card is read
and
recorded on a new card so that
the time code continues in running
order.
(A P78 [Setting Time Code] )
Memo :
0
When [System] B [Record
Set] B [Rec Mode] is
set to “Interval Rec” or “Frame Rec”, and [TC
Generator] is set to “Free Run”, “Free Run
(Ext)” or “Free Run(NTP)”, “Rec Run” is
activated.
0
When [System] B [Record Set
] B [Record
Format] B [System] is set to “High-Speed”, and
[TC Generator] is set to “Free Run”, “Free Run
(Ext)” or “Free Run(NTP)”, “Rec Run” is
activated.
Setting Time Code
Generator
Presetting the Time Code
Time code and user’s bit data generated from the
internal time code generator are recorded.
This section describes how to set
[TC/UB] B [TC
Preset].
(A P125 [ TC Preset ] )
Memo :
0
When [System
] B [Record Set] B [Record
Format] B [WFrame Rate] is set to “50p”, “50i”,
“25p” or “24p”, setting for “Drop” will be disabled.
(A P
158 [WFrame Rate/ GFrame Rate] )
0
You
can configure the setting without accessing
the [TC/UB] menu screen.
(A P79 [Setting Time Code without Opening
the Menu] )
Required Settings Before Preset
1
Set [TC/UB] B [TC Generator
] to “Rec Run”
or “Free Run”.
(A
P125 [ TC Generator ] )
0
[Rec Run
]:
Preset data in the time code generator
operates in run mode during recording mode.
Set this when recording continuous time
code in connecting frames.
0
[Free Run]:
Time code starts to operate in run mode from
the preset time in the time code generator.
Time Code and User’s Bit
77
Shooting