INSTRUCTIONS

Audio Recording
You
can record audio from the two channels (CH1/
CH2) in synchronization with video images on this
camera recorder.
Select from the options below to record the audio.
0
Built-in Microphone
0
Microphone connected to
[AUX] terminal
0
Microphone connected to [INPUT1] terminal
0
Microphone connected to [INPUT2] terminal
.
CH1
INT
INPUT1
INPUT2
AUTO
MANUAL
CH2 INPUT2INPUT1
PEAKINGLCD BRIGHT
CH2CH1
LINE
MIC
MIC
+48V
Selecting Audio to Be Recorded in Each
Channel
Select the audio to be recorded in CH1/CH2.
- Switch Setting Connected Devices
CH1 INT
0
Built-in Microphone
0
Microphone connected to
[AUX] terminal
INPUT1 Microphone connected to
[INPUT1
] terminal
CH2 INT
0
Built-in Microphone
0
Microphone connected to
[
AUX] terminal
INPUT1 Microphone connected to
[INPUT1] terminal
INPUT2 Microphone connected to
[
INPUT2] terminal
Memo :
0
When “INT” is set, the built-in microphone is
disabled if a microphone is connected to the
[AUX] terminal; audio from the microphone
connected to the [AUX] is recorded.
0
When “INT” is selected, set the reference input
level in [A/V Set] B [Audio Set] B [Int. Mic Gain]/
[AUX Gain].
(A P135
[ Int. Mic Gain ] )
(A P135 [ AUX Gain ] )
Setting Input Channel to [INPUT1]/[INPUT2]
Select
the audio to input to [INPUT1] and [INPUT2]
terminals with the [INPUT1]/[INPUT2] mode
switch.
Setting Description
[LINE] Use this setting when connecting to
an
audio device or other equipment.
The reference input level is +4 dBu.
[MIC] Use this setting when connecting to
a dynamic microphone.
[MIC+48V] Use this setting when connecting to
a microphone (phantom
microphone) that requires a +48 V
power supply.
Memo :
0
When “MIC” or “MIC+48V” is selected, set the
reference input level in [A/V Set] B [Audio Set]
B [Input1 Mic Ref.
]/[Input2 Mic Ref.].
(A P135
[ Input1 Mic Ref. ] )
(A P135 [ Input2 Mic Ref. ] )
Caution :
0
When
connecting a device that does not require
a +48 V power supply, make sure that it is not
set to the “MIC+48V” position.
0
When the [INPUT1]/[INPUT2] mode switch is
set to “MIC”, make sure that a microphone is
connected to the [INPUT1]/[INPUT2] terminal. If
you increase the recording level when a
microphone is not connected, noise from the
input terminal may be recorded.
0
When a microphone is not connected to the
[INPUT1]/[INPUT2] terminal, set the [INPUT1]/
[INPUT2] mode switch to “LINE” or adjust the
volume with the [CH1]/[CH2] recording level
adjustment knob.
74
Audio Recording
Shooting