INSTRUCTIONS

Zoom Operation
Adjusts the angle of view.
Optical zoom ratio: 1x to 20x
Dynamic zoom ratio: 1x to 40x
Set
using [Camera Function] B [Zoom] B [Dynamic
Zoom].
(A P113 [ Dynamic Zoom ] )
Zooming can be operated using the following.
0
Zoom Lever at the Grip
0
Zoom Lever on Handle
0
Zoom Ring at the Lens Section
During the zoom operation, the zoom bar or
number
will appear on the upper right corner of the
screen.
(A P169 [Zoom Display] )
Caution :
0
Depending on the zoom speed, the zoom drive
noise of the power zoom may be recorded.
Using the Zoom Lever at the Grip
1
Press the zoom lever to zoom.
0
The zoom speed changes according to the
extent the zoom lever is being pushed.
0
Zooms into wide angle and increases the
angle of view when
“W” is pressed.
0
Zooms into telephoto and decreases the
angle of view when “T” is pressed.
Using the Zoom Lever at the Handle
1
Set the [FIX/VAR/OFF] zoom speed switch
to “
FIX” or “VAR”.
Memo :
0
Setting to “FIX” will allow the zoom operation to
move
at the speed set in [Handle Zoom Speed].
0
Set the zoom speed using [Camera
Function] B [Zoom] B [Handle Zoom Speed].
(A
P113 [ Handle Zoom Speed ] )
2
Press the zoom lever at the handle to zoom.
Memo :
0
When the [FIX/VAR/OFF] zoom speed switch is
set to “OFF”, the zoom lever at the handle
section cannot be used.
Using Zoom Ring at the Lens Section
You can adjust the preferred angle of view by
turning the zoom ring.
Saving/Recalling Current Zoom
Position (Preset Zoom)
This allows you to register up to three zoom
positions.
1
Assign the “Preset Zoom1”, “Preset
Zoom2”,
or “Preset Zoom3” function to any
of the user buttons.
(A P
46 [Assignment of Functions to User
Buttons] )
(A P116 [USER1 to USER9, USER10 ▲,
USER11 ▼, USER12 ◀, USER13 ▶] )
2
Save the current zoom position.
0
Press any of the user buttons assigned with
the “Preset Zoom1
”, “Preset Zoom2”, or
“Preset Zoom3” function for more than 1
second.
0
The current zoom position will be stored.
3
Recall the stored zoom position.
0
Press any of the user buttons assigned with
the “Preset Zoom1
”, “Preset Zoom2”, or
“Preset Zoom3” function and release within 1
second.
0
The camera recorder zooms to the stored
zoom position.
Memo :
0
Set the speed for shifting to the preset zoom
position and the rate of change for starting and
stopping the preset zoom operation in [Camera
Function] B [Zoom] B [Preset Zoom] B [Speed]/
[Ease In]/[Ease Out].
(A
P114 [ Preset Zoom ] )
0
Operating other zoom maneuvers during a
zoom position recall will cancel the recall.
Zoom Operation
59
Shooting