INSTRUCTIONS

Server
For selecting the server for live streaming.
[Setting Values: RServer1, Server2, Server3,
Server4]
Memo :
0
The setting cannot be changed during live
streaming (when [Live Streaming] set to “On”).
9
Streaming Server
For setting the server for live streaming.
Memo :
0
The setting cannot be changed during live
streaming (when
[Live Streaming] set to “On”).
9
Server1, Server2, Server3, Server4
*
The name that is set in [Alias] is displayed
individually.
o
Alias
For setting a name to distinguish the settings of this
camera.
The name set in this item will be displayed in the
[Server] options.
*1
The default value is “Server1/Server2/
Server3/Server4”.
*2 You can enter up to 31 characters and ASCII
characters.
o
Type
For configuring the system for transferring video
and audio to be distributed.
[Setting Values: RMPEG2-TS/UDP, MPEG2-TS/
TCP, MPEG2-TS/RTP, RTSP/RTP, ZIXI(SRT),
RTMP, RTMPS, Facebook Live, YouTube Live]
A
[Setting Values: RMPEG2-TS/UDP, MPEG2-TS/
TCP, MPEG2-TS/RTP, RTSP/RTP, SRT, RTMP,
RTMPS, Facebook Live, YouTube Live] B
Memo :
0
Use reception devices that are compatible with
the respective transfer systems.
0
To use the
“ZIXI” setting, a dedicated server is
needed separately. A
0
The
GY-HC550 is a model that is equipped with
the Zixi protocol, thus SRT protocol update
needs to be performed before using the SRT
protocol. Doing so will make the Zixi protocol
unusable.
To enable the use of the Zixi protocol again,
perform Zixi protocol update.
0
The following items that can be set vary
depending on the setting of this item.
o
Connection Mode
For configuring the SRT connection mode.
[Setting Values: RCaller, Listener, Rendezvous]
Memo :
0
This
item is selectable only when [Type] is set to
“SRT”.
o
Destination Address
For setting details such as the host name and the
IP address of the live distribution destination.
*
Enter not more than 127 characters using
single-byte alphanumeric characters (a to z, 0 to
9), single-byte hyphen [-], or dot [.].
o
Destination URL
For entering the URL of the live distribution
destination beginning with “rtmp://
” or “rtmps://”.
There is no default value (blank).
* You can enter up to 191 characters and ASCII
characters.
Memo :
0
Available when
[Type] is set to “RTMP” or
“RTMPS”.
o
Destination Port
Enter the network port number of the live
distribution
destination using an integer between 1
and 65535.
When [Type] is set to “MPEG2-TS/UDP”, “MPEG2-
TS/TCP” or “MPEG2-TS/RTP”, the default value is
“6504”. If “ZIXI” is set, the default value is “2088”.
Memo :
0
When [
Type] is set to “MPEG2-TS/RTP”, only
even numbers from 2 to 65530 can be specified
for the port number.
0
When [Type] is set to “MPEG2-TS/RTP” and
[SMPTE 2022-1 FEC] is set to “On”, N+2 and N
+4 port numbers are also used in addition to the
specified port number (N).
Network Menu
141
Menu Display and Detailed Settings