INSTRUCTIONS

IFB/RET Monitor...
9
CH1(/2)
For configuring the output from the [x] terminal
during IFB Return over IP of each channel.
0
Auto:
Outputs upon mixing the IFB/Return over IP
audio with the microphone audio when IFB/
Return over IP audio input is detected. Outputs
only the microphone audio when IFB/Return
over IP audio input is not detected.
0
IFB/RET Only:
Outputs only the IFB/Return over IP audio at all
times.
0
Off:
IFB/Return over IP audio is not output.
[Setting Values: RAuto, IFB/RET Only, Off]
Memo :
0
To
enable different settings for CH1 and CH2 of
[IFB/RET Monitor], set [Monitor] to “Stereo”.
Alarm Level
For selecting whether to turn on the warning tone
as well as setting the volume.
The warning tone is output from the monitor
speaker or [x] terminal.
[Setting Values: RHigh, Middle, Low, Off]
Audio On FULL AUTO
For setting whether to enable Auto for audio when
the [FULL AUTO] switch is set to “ON”.
0
Auto:
Sets audio recording mode to the auto mode.
0
SW Set:
Sets the audio recording mode following the
[CH1/CH2 AUTO/MANUAL] selection switch
setting.
[Setting Values: RAuto, SW Set]
A/V Set Menu
137
Menu Display and Detailed Settings