User Guide

Holding this Unit
When holding this unit, keep your elbows close to your sides to prevent
camera shake.
.
0
Hold the LCD monitor with your left hand and adjust the angle accordingly.
Holding the LCD monitor with your left hand helps to stabilize the camera
for recording.
Caution :
0
Be careful not to drop this unit during transportation.
0
Guardians should pay close attention when this unit is being used by
children.
Memo :
0
If camera shake is excessive, use the digital image stabilizer.
“Reducing Camera Shake” (A p. 44)
Tripod Mounting
This unit can be mounted on a tripod (or monopod). This is useful for
preventing camera shake.
.
0
To prevent this unit from falling off, check the tripod mounting screw holes
and positioning holes on the unit carefully before mounting, and turn the
screws until they are fastened firmly.
Caution :
0
To prevent injuries or damages which may result if this unit falls off, read
the instruction manual of the tripod (or monopod) to be used and make
sure that it is securely attached.
Memo :
0
It is recommended to use a tripod or monopod when recording in
conditions prone to camera shake (such as in dark places or when zoomed
to the telephoto end).
0
Set the digital image stabilizer to Z (OFF) when using a tripod for
recording.
“Reducing Camera Shake” (A p. 44)
Using the Remote Control
You can operate this unit from a distance away using the supplied remote
control.
.
Memo :
0
Point the remote control toward the sensor directly and use it within 5 m
from this unit.
0
The transmitted beam may not be effective or may cause incorrect
operation when the sensor is directly exposed to sunlight or powerful
lighting.
Preparing the Remote Control
Using the Remote Control for the First Time
.
0
A button battery (CR2025) is included inside the remote control at the time
of purchase.
Remove the insulation sheet before use.
Reinserting the Battery
.
0
Pull out the battery holder by pressing the lock tab.
0
Insert the button battery with the + side facing upward.
Getting Started
22