Manual
EN73
33. Colored bright spots appear all
over the LCD monitor or the
viewfinder.
34. The indicators and the image
color on the LCD monitor are ....
not clear.
35. The cassette will not load • Install a fully charged battery.
properly. (_-_"pg. I 0, 11)
36. The memory card cannot be • Push in the memory card a
removed from the camcorder, few more times. (_-_"pg. 16)
37. Picture does not appear on the • Push the viewfinder back in
LCD monitor, or set "PRIORITY" to "LCD'.
(_:y pg. 12, 31, 38)
• Adjust the brightness of the
LCD monitor. (_: pg. 13)
• If the monitor is tilted
upward 180 degrees, open
the monitor fully. (_* pg. 12)
38. Images on the LCD monitor • Turn the speaker volume
are jittery, down. (_ pg. 20)
39. The LCD monitor, the • Wipe them gently with soft
viewfinder and the lens have cloth. Wiping strongly can
become dirty (ex. fingerprints), cause damage. (::y pg. 77) To
clean the viewfinder, please
consult your nearest ]VC
dealer.
40. Time code does not appear. • Set "TIME CODE" to "ON".
(_-ypg. 31, 38, 41)
41. An error indication (E01, E02 • _-_:pg. 85.
or E06) appears.
42. An error indication (E03 or •_-;: pg. 85.
E04) appears.
43. The remote control does not
work.
33. • The LCD monitor and the 33.
viewfinder are made with
high-precision technology.
However, black spots or
bright spots of light (red,
green or blue) may appear
constantly on the LCD
monitor or the viewfinder.
These spots are not recorded
on the tape. This is not due to
any defect of the unit.
(Effective dots: more than
99.99 %)
34. • This may occur when the 34.
surface or the edge of the
LCD monitor is pressed.
35. • The battery's charge is low. 35.
36. 36.
3Y. -The viewfinder is pulled out 37.
and "PRIORITY" is set to
"FINDER".
• The LCD monitor's brightness
setting is too dark.
38. • The speaker volume is too 38.
great.
39. 39.
40. • "TIME CODE" is set to 40.
"OFF".
41. -A malfunction of some kind 41.
has occured. In this case the
camcorder's functions
become unusable.
42. -Amalfunctionofsomekind 42.
has occured. In this case the
camcorder's functions
become unusable.
43. • "REMOTE" is set to "OFF", 43.
• The remote control does not
point at the remote sensor.
• The remote control batteries
are exhausted.
• Set "REMOTE" to "ON".
(_:y pg. 31, 37)
• Point at the remote sensor.
(_:Ypg. 56)
• Replace the batteries with
fresh ones. (r_* pg. 56)