Manual

66EN
I ConnectionToA PersonalComputer
[A] Using USB cable
SYSTEM CONNECTIONS
To USB
DV cable
To USB connector
USB cable (provided)
PC
OR
DV cable To DV
(optional) connector
[o DVIN/OUT
PC with DV
connector
[A] UsingUSBcable
It is possible to do the following things:
• Transfer still images stored on a memory card to a
PC.
• Transfer stilt/moving images recorded on a tape to
a PC.
• Capture still/moving images in real-time.
• Use this camcorder as a WebCam. (r__pg. 67)
[B] UsingDVcable
It is also possible to transfer still/moving images to a
PC with a DV connector by using the provided
software, software equipped with the PC or
commercially available software.
NOTES:
• Refer to "SOFTWARE INSTALLATION AND USB
CONNECTION GUIDE" for the installation of the
bundled software and drivers.
• Thesoftware operation manual isprovided as PDF
file on the CD-ROM.
• It isrecommended to use the AC Adapter as the
power supply instead of the battery pack.
p_pg. 11)
• Never connect the USB cable and the DV cable
simultaneously to the camcorder. Connect only
the cable you wish to use to the camcorder.
• When using a DV cable, be sure to use the
optional JVC VC-VDV206U or VC-VDV204U DV
cable depending on the type of DV connector (4
or 6 pins) on the PC.
• If the PC connected to the camcorder via the USB
cable is not powered_ the camcorder does not
enter the USB mode.
• The date/time information cannot be captured into
the PC.
• Refer to the instruction manuals of the PC and
Software.
• The still images can also be transferred to a PC
with a DV connectoroequipped capture board.
• The system may not work properly depending on
the PC"or capture board you are using.
"USB MODE" and/or "ACCESSING FILES"
appears on the LCD monitor while the PC is
accessing data in the camcorder or the camcorder
is transferring a file to the PC.
NEVER disconnect the USB cable while
"ACCESSING FILES"is displayed on the LCD
monitor since this can result in product damage.