Manual

EN83
Select Scenes
-FADE/WIPE
FFFIECT EDiT IN/OUT ON/OFF
RM-V717U (provided RM-V700U
with GR-DVg00 only) (optional)
6 Press PLAY (1_)and then press R.A.EDIT ON/OFF
on the remote control.
The Random Assemble Selected parameter
Editing Menu appears.
7 For GR-DVg00 owners:
If using a Wipe/Fader at
the beginning of the
scene, press FADE/WIPE
on the remote control
• Cycle through the
effects by pressing
repeatedly, and stop when the one you want is
displayed.
• You cannot use a Picture Wipe/Dissolve at the
beginning of Program 1.
8 At the beginning of the scene, press EDIT IN/
OUT or IN/OUT on the remote control. The Edit-
In position appears in the Random Assemble
Editing Menu.
9 At the end of the scene, press EDIT IN/OUT or
IN/OUT. The Edit-Out position appears in the
Random Assemble Editing Menu.
10 For GR-DV90B owners: If using a Wipe/Fader
at the end of the scene, press FADE/WIPE.
• Cycle through the effects by pressing
repeatedly, and stop when the one you want is
disptayed.
• If you select a Wipe/Fader effect for an Edit-Out
point, the effect is automatically applied to the
following Edit-In point.
• You cannot use a Picture Wipe/Disso]ve at the
end of the last scene.
• When you use FaderA_Vipeeffects, that time is
included in the total time (this does not apply
to Picture Wipe/Dissolved
1 1 For GR-DVg00 owners: If using Playback
Special Effects, press EFFECT.(_-z-pg. 58)
1 2 Repeat steps 8 through 11 to register
additional scenes.
• To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently regis/ered point.
• If you are not using Wipe/Fader (GR-DV900
only) or Program AE with special effects, repeat
steps 8 and 9 only.
NOTES:
• When choosing a scene_set Edit-In and Edit-Out
points so that there is a relatively large difference
between them.
• If the search time for an in-point exceeds
5 minutes, the recording deckg Record-Standby
mode will be cancelled and editing will not take
place.
• If there are blank portions before or after the Edit-
In and Edit-Outpoints, a blue screen may be
included in the edited version.
• Since time codes register time only as accurately
as seconds, the time code total time may not
match the total program time exactl_z
• Turning offthe camcorderg power erases all
registered Edit-In and Edit-Out points.
• For GR-DVgOO owners: If you select ,Sepiaor
Monotone mode from Program AE with special
effects, you cannot use the Dissolve or Black &
White, Fade_ In this case the Dissolve or Black &
White indicator begins blinking. Once the next
Edit-In point is registered, the effect is turned off.
Tocombine these effects, use Sepia or Monotone
during recording, then use the Dissolve or Black &
White Fader during Random Assemble Editing.
• For GR-DVgOO owners: It is not possible to use
Wipe/Fader effects and Program AE with special
effects durB_g Random Assemble Editing using a
DV cable.
CONTINUED ON NEXT PAGE