Manual

EN53
I ubbingToAVideoUnitEquipped
WithA DV IN Connector
(DigitalDubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a
DV connector. Since a digitat signal is sent, there is
litge if any image or sound deterioration.
Video unit equipped with DV
connector
1 Make sure all units are turned off.
2 Connect this camcorder to a video unit equipped
with a DV input connector using a DV cable as
shown in the iHustragon.
3 Set this camcorder's VIDEO/MEMORY Switch to
"VIDEO'.
4 Set this camcorder's Power Switch N) "PLAY"
white pressing down the Lock Button tocated on
the switch.
5 Turn on the video unit's power.
6 Insert the source cassette in this camcorder.
7 Insert the recording cassette in the video unit.
8 Press1_/11 on this camcorder to start playback of
the source cassette.
9 At the point you want to start dubbing, engage
the video unit's Record mode.
10 To pause dubbing, engage the video unit's
Record-Pause mode and press I_/11 on this
camcorder.
1 1 Repeat steps 8 .. lgforadditiona[ediBng,Stop
the video unit and camcorder.
NOTES:
• It isrecommended to use the AC Adapter asthe
power supply instead of the battery pack_
(_ pg. 11)
• Iftheremotecontrolisusedwhenboththeplayer
and recorder are JVC video units, both units will
perform the same operation. Toprevent this from
happening, press the buttons on both units.
• If a blank portion or disturbed image isplayed
back on the player during dubbing, the dubbing
may stop so that an unusual image is not dubbed.
• Even though the DV cable is connected correcdy,
sometimes the image may not appear in step 9. If
this occurs, turn off the power and make
connections again.
• If "Title Impose" I::__pg, 44), "Playback Zoom"
I:; _pg, 58) or "Playback Special Effects"
I:"_ pg. 58) is attempted or SNAPSHOT is pressed
during playback, only the original playback image
recorded on the tape is output from the DV IN/
OUT connector.
• When using a DV cable, be sure to use the
optional JVC VC-VDV204U DV cable.