Manual

14 EN
I Date/TimeSettings
The date/time is recorded onto the tape at all times,
but its display can be turned on or off during
playback. (_ pg. 3I, 41 )
MENU Whee) -
Power/Charge -
Lamp
Lock Button
PowerSwitch
1 Set the Power Switch to "_" while pressing down
the Lock Button located on the switch.
2 Open the LCD monitor fully, or pull out the
viewfinder fully.
3 Press the MENU Wheel in.
The Menu Screen appears.
Built-inClock'sRechargeableLithiumBattery
To store the date/time in memory, the clock's
rechargeable lithium battery is integrated in the
camcorder. While the camcorder is connected to an
AC outlet using the AC Adapter, or while the battery
]sack attached to the camcorder continues to supply
]sower, the dock's rechargeabIe lithium battery is
always charged. However, if the camcorder is not
use(] for approx. 3 months, the clock's lithium
battery wiIl become discharged and the date/time
stored' in memory will be Iost. When this occurs, first
connect the camcorder to an AC outlet using the AC
Adapter for over 24 hours to charge the clock's
rechargeable hthium battery. Then perform the data/
time setting before using the camcorder.
Note that the camcorder can be used without setting
the date/time.
NOTE:
Even ff you select "CLOCK ADJ.'; if the parameter is
not highlighted, the camcorder's internal clock
continues to operate. Once you move the highlight
bar to the first date/time parameter (month), the
clock stops. When you finish setting the minute and
press the MENU Wheel in, the date and time begin
operation from the date and time you have just set.
4 Rotate the MENU Wheel
to select "M", and press
it. The CAMERA DISPLAY
Menu appears.
5 Rotate the MENU Wheel
to select "CLOCK ADL',
and press it. The
parameter for "Month" is highlighted.
6 Rotate the MENU Wheel
to input the month, and
press it. Repeat to input
the day, year, hour and
minute.
7 Rotate the MENU Wheel
to select "URETURN', and
press it twice. The Menu Screen closes.