Operation Manual

Master Page: Right
—7—
[Setup Status] screen appears. Wait
for a moment until the installation is
finished.
When the installation is finished,
[Digital Photo Navigator Setup] screen
appears and asks you if you want to
create the icon on the desktop.
If you need it, click [Yes]. If not, click
[No].
Install all of the desired software or
driver in the same way.
To display [SETUP] screen, double-click the
CD-ROM icon in the [My Computer]
window.
NOTE:
If you perform installation of a software that
is already installed, uninstallation will start.
In this case, perform the installation again
after uninstallation is finished.
If the camcorder is connected to the PC
with the USB cable before installing [USB
Mass Storage Class driver], the installation
might not be performed properly.
In this case, follow the procedure described
below to update the [Device Manager] and
install [USB Mass Storage Class driver]
properly.
NOTE:
Disconnect any other USB audio devices
from PC before performing the following
procedure.
Installing [USB Mass Storage Class driver]
1 Use the USB cable to connect
the camcorder to the PC.
(墌 pg. 8)
2 Click [Start], go to [Settings],
and then click [Control Panel].
Double click the [System] icon.
3 Select the [Device Manager] tab.
4 Delete [GR-D270*] in [Other
devices].
* The model name depends on the
connected camcorder.
5 Disconnect the USB cable from
the camcorder. Restart the PC.
6 Load the provided CD-ROM into
the PC. Install [USB Mass
Storage Class driver]. (墌 pg. 6)
7 Use the USB cable to connect
the camcorder to the PC.
Device driver is installed.
8 Confirm the [Removable Disk]
icon is displayed in [My
Computer].
Updating [Device Manager]
(Windows
®
98SE only)
M5D2_D5+DSC_glb_InstaGuide.fm Page 7 Monday, October 25, 2004 2:48 PM