User Manual

28
Specifications
General
Model name DT-V9L5
Type Multi format LCD monitor
Screen size Type 8.2 wide format
Aspect ratio 16:10
Compliant video signal format
☞ “Available signals” on page 30
Format HD SDI: SMPTE292M
SD SDI: ITU-R BT.656, SMPTE259M
EMBEDDED AUDIO 16CH: SMPTE299M, SMPTE272M
Audio output Internal speaker: 1.0 W
Operating conditions Operating temperature: 5°C – 35°C
Operating humidity: 20% – 80% (non-condensing)
(Slightly variable depending on ambient conditions for installation.)
Power requirements AC 120 V / AC 220 V – 240 V, 50 Hz/60 Hz or DC 12 V – 17 V
Rated current 0.5 A (AC 120 V)
0.25 A (AC 220 V – 240 V)
1.3 A (DC 12 V – 17 V)
External dimensions
(excluding protruding parts)
with the stand without the stand
Width: 217 mm Width: 217 mm
Height: 218 mm Height: 176 mm
Depth: 185 mm Depth: 116 mm
Weight 3.2 kg (with the stand)
2.3 kg (without the stand)
Accessories AC power cord x 2, Power cord holder x 1, Screw x 2 (for power cord holder), Protective filter x 1,
Screw (for protective filter) x 4
LCD panel
Type 8.2˝ wide, active matrix TFT
Effective screen size Width: 176.4 mm
Height: 110.4 mm
Diagonal: 208.3 mm
Number of pixels displayed 1280 x 800
Number of colors displayed 16.70 million
Viewing angle (TYP.) 80° (Horizontally), 80° (Vertically)
Brightness (TYP.) 360 cd/m
2
Contrast ratio (TYP.) 800:1
Input/output terminals
Video
VIDEO Input/output of composite signal: 1 line, BNC connector x 2, 1 V (p-p), 75 
* The input (IN) and output (OUT) terminals are bridge-connected
(auto termination).
HDMI
HDMI signal input (compatible with HDCP) : HDMI connector x 1
COMPO.
(Y, Pb/B-Y, Pr/R-Y)
Analog Component signal input: 1 Line, BNC connector x3
Y: 1 V(p-p), 75 (with sync)
PB/B-Y, PR/R-Y: 0.7 V (p-p), 75 
E. AUDIO HD/SD SDI (IN 1) Digital signal input (compatible with EMBEDDED AUDIO signals):
auto detection, 2 line, BNC connector x 2
E. AUDIO HD/SD SDI (IN 2)
E. AUDIO HD/SD SDI
(SWITCHED OUT)
Digital signal output (compatible with EMBEDDED AUDIO signals):
1 line switched out, BNC connector x 1
Audio
AUDIO (IN) Analog audio signal input: 1 line, RCA connector x 1, 500 mV (rms), high impedance
AUDIO (MONITOR OUT) Analog audio signal output: 2 line, RCA connector x 2, 500 mV (rms)
External
control
REMOTE (MAKE/TRIGGER)
☞ “Using the MAKE/TRIGGER system” on page 23
REMOTE (RS-232C)
☞ “Using the serial communication” on page 24
DT-V9L5_EU_EN_1.indb 28DT-V9L5_EU_EN_1.indb 28 10/10/2012 3:51:08 PM10/10/2012 3:51:08 PM