Manual

You can operate your TV from the remote control unit.
Setting the remote control signal for
operating your TV
TV STANDBY/ON
OIl
CZ.3 C_3 _
ENTER _,_, _/
• ] C_ 5d
L
Set the TV - DVD switch to "TV".
TV - DVD switch
, - Numeric buttons
-- TVNIDEO -
CANCEL
2 Hold down TVNIDEO - CANCEL until step 4 is
finished.
3 Enter the manufacturer code of your TV listed below
by using the numeric buttons (0 through 9).
Example:
To enter the manufacturer code "01 ": Press "0" then
iI 1 u,
• When the unit is shipped, the manufacturer code is set to
"JVC" (01).
4 Press ENTER.
Manufacturer code list
AIWA
BEIJING
CCE
CHANGHONG
DAEWOO
FERGUSON
FINLUX
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JINXING
JVC
KONKA
LG (GOLDSTAR
MAGNAVOX
MITSUBISHI
36
22
02
34
17, 37
27
30
32
15, 20
19
10
28
38
01, 23,
24, 25
40
18
02
O3
MIVAR
NEC
NOBLEX
NOKIA
PANASONIC
PEONY
PHILCO
PHILIPS
RCA
SAMSUNG
SANYO
SEARS
SHARP
SONY
TCL
THOMSON
TOSHIBA
ZENITH
29
20
22
31
04, 11
34, 38, 39
10, 17, 21
O2
05
12, 33, 34,
35
13, 16
13
O6
O7
41
26
08,14
O9
Getting started
5 Release TVNIDEO - CANCEL.
6 Try to operate the TV by pressing TV STANDBY/ON
(bit.
If your TV turns on or off, you have successfully set
the control signal.
The following buttons can be used for operating the
-IV.
To use A/v (CH-, CH+), </I_(VOL-, VOL+), TVNIDEO -
CANCEL and numeric buttons for TV control, set the
TV - DVD switch to "TV".
TV
TVMDEO
CANCEL
TV_ TV-/-
_2J _ _!D
TVO
Turns the TV on or off.
Switches the TV input mode between TV
and VIDEO.
Selects the TV channels directly.
* For some TVs, pressing "+10" functions
as the "100+," while "10" functions as the
ENTER button if your TV requires
pressing the ENTER button after
selecting a channel number.
MUTING Mutes the TV sound,
Changesthe TV channels.
Adjusts the TV volume.
VOL- VOL*
NOTE
• If there is more than one code listed for the
manufacturer of your TV, try them one by one until you
succeed.
You can control the volume of a JVC's amplifier or
receiver by using the AMP VOL +/- buttons on the
remote control unit.
-- AMP VOL -I-
CC3 CC)
Pressing the + button raises the audio volume of the
amplifier or receiver, while pressing the - button lowers
the volume.
11