Manual

AM Antenna Connections
ANTENNA--
FM75Z2
Snap the tabs on the loop flame
into the slots of the base to
assemble the AM loop.
Basic connecting procedure
1 2 3
2
3
(not supplied)
2
3
Cut, twist and remove the insulation at the end of
each speaker signal cable (not supplied).
Open the terminal and then insert the speaker
signal cable.
Close the terminal.
Connecting the front speakers
You can connect two pairs of front speakers (one pair to the FRONT
SPEAKERS ,1) terminals, and another pair to the FRONT
SPEAKERS, : term nals).
Right speaker FRONT SPEAKERS (1) Left speaker
Turn the loop antenna until you have the best reception.
Notes:
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. This could cause poor
reception.
• If reception is poor, connect an outdoor single vinyl-covered wire to
the AM EXT terminal. (Keep the AM loop antenna connected.)
You can connect the following speakers:
• Two pairs of fiont speakers to produce normal stereo sound.
• One pair of rear speakers to enjoy the surround effect.
• One center speaker to produce more effective surround effect (to
emphasize human voices).
• One subwoofer to enhance the bass.
IMPORTANT:
After connecting the speakers listed above, set the speaker
setting intbrmation properly to obtain the best possible DSP
effect. Vor details, see page 12.
For each speaker (except for a subwoofer), connect the () and (+)
terminals on the rear panel to the () and (+) terminals marked on
the speakers. For connecting a subwoofer, see page 5.
- FRONTSPEAKERS
Right speaker FRONT SPEAKERS, , Left speaker
Connecting the rear and center speakers
Connect real- speakers to the P,EAP, SPEAKERS terminals and a
center speaker to the CENTER SPEAKER terminals.
Center speaker
Left rear Right rear
speaker speaker
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
4