Manual

Operating JVC's Audio/Video Components
You can operate JVC's audio and video components with this receiver's remote control, since control signals for JVC
components are preset in the remote control.
IMPORTANT: Sound control section (AmDlifierl
To operate JVC's audio components using this remote control: You can always perform the following operations:
• You need to connect JVC audio components through the COMPU
LINK-3 (SYNCHRO) jacks (see page 26) in addition to the
connections using cables with RCA pin plugs (see page 5).
• Aim the remote control directly at the remote sensor on the receiver.
• If you use the buttons on the front panel to choose a source, the
remote control will not operate that source. To operate a source with
the remote control, the source must be selected using source
selecting buttons on the remote control.
• To operate the cassette deck or MD recorder using the COMPU
LINK remote control system, set the source name correctly. (See
page 11 .)
• Refer also to the manuals supplied with your components.
.IVn
SURROUND:
SURROUND MODE:
Turns on or oil" the Surrotmd modes ............
Dolby Pro Logic, Dolby Digital, and DTS
Digital Surround.
Selects the DSP modes.
After pressing SOUND, you can perform the following operations:
SUBWOOFER - / +: Adjusts the subwoofer output level.
CENTER - l +: Adjusts the center speaker output level.
REAR°L - l +: Adjusts the left rear speaker output level.
REAR'R - / +: Adjusts the right rear speaker output level.
EFFECT: Selects the effect level.
TEST: ]_rns on or off the test tone output.
Note:
After adjusting sounds, press the corresponding source selecting
button or CD-DISC to operate your target source by using the 10
keys; otherwise, the 10 keys cannot be used for operating your target
sout'ce.
Turntable
After pressing PHONO, you can perform the following operations
on a turntable:
D,-: Starts playing.
I1: Stops operations.
After pressing CD, you can perform the following operations on the
CD player:
[l_lP[:
i:
I1:
1 - 10, +10:
Starts playing.
Returns to the beginning of the current (or
previous) track.
Skips to the beginning of the next track.
Stops playing.
Pauses playing. '1_ release it, press I_.
Selects a track number directly.
For track number 5, press 5.
For track number 15, press +10, then 5.
For track number 20, press +10, then 10.
For track number 30, press +10, -710, then 10.
Tuner
After pressing FM/AM, you can perform the following operations:
FMIAM: Alternates between FM and AM.
1 - 1 O, +1 O: Selects a preset channel number directly.
For channel number 5, press 5.
For channel number 15, press + 10, then 5.
For channel number 20, press -710, then 10.
29