Manual

You can adjust the subwoofer output level if you have selected
"YES" for the "SUBWOOFER" (see page 11).
Once it has been adjusted, the receiver memorizes the adjustment.
Befbre you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start fi-om step 1 again.
With this Bass Boost function, you can boost the bass level.
Befbre you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
On the front panel:
l, Press ADJUST repeatedly until ADJUST
"SUBWFR LEVEL" appears on _===_¢_
the display.
• Once you have pressed ADJUST, MULTI CURSOR A / V
can be also used for selecting "SUBWFR LEVEL."
• The display changes to show the current setting.
2. Press MULTI CURSOR <_ / _ to ...........
adjust the subwoofer output level [ IL I
From the remote control: SOUND
1. Press SOUND. ('_--_.
The 10 keys are activated for sound adjustments.
I.
Press ADJUST repeatedly until ADJUST
"BASSBOOST" (with the current
setting) appears on the display.
• Once you have pressed ADJUST, MULTI CURSOR A / V
can be also used for selecting "BASSBOOSTY
. Press MULTI CURSOR <_ / E> to
switch this function "ON" or
"OFF."
• When this function is switched "ON," the
BASS BOOST indicator on the display
lights up.
Note:
TheBass Boost function affects the front speaker sounds only
2. Press SUBWOOFER-/+ to adjust - SUBWOOFER+
thesubwooferoutputlevel(-lOdB 0 0 '' ' " ' "
to +10 dg). _> Youcan adjust the treble and bass sounds as you like,
When the input level of the playing source is too high, the sounds
will be distorted, if this happens, you need to attenuate the input
signal level to prevent the sound distortion.
On the front panel ONLY:
P d h ld INPUTAT'I: (ONE TOUCH
tess an 0 osE_oucHO_ER,_T_ONt
OPERRATION) so that the ATT indicator
lights up on the display.
• Each time you press and hold the button, the
Input Attenuator mode turns on ("INPUT AFT
ON") or off ("INPUT NORMAL").
Notes:
• This function is available only for the sources connected using the
analog terminals.
• Thisfunctiondoesnottakeeffectwhendigitalinputisselected.
Betbre you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press ADJUST repeatedly until
ADJUST
"BASS" or "TREBLE" appears on
the display.
• Once you have pressed ADJUST, MULTI CURSOR A / V
can be also used for selecting "BASS" or "TREBLE."
• Select "BASS" to adjust the bass sound level.
• Select "TREBLE" to adiust the treble sound level.
. Press MULTI CURSOL <3 / _ to
adjust the bass or treble sound
level within the range of-10 to
+10.
• Each time you press the button, the sound
_uL_lCU_OR
level changes by ± 2 steps.
10