OperationManual

Viewing Videos
MEMO
0
Connect the power cord, and ensure that the “STANDBY/ON” indicator
lights up in red.
1
Turn on the power
Remote control: press the C [ON] button
Projector unit: press the A button
LIGHTWARNING
STANDBY/ON
LIGHTWARNING
STANDBY/ON
DB
AN
BY/O
DB
AN
BY/O
When LD block is starting up
“STANDBY/ON” lights up (green)
In standby state
“STANDBY/ON” lights up (red)
2
Choose the image to project
Remote control:
Button Terminal
[INPUT 1] DisplayPort 1
[INPUT 2] DisplayPort 2
[INPUT 3] DisplayPort 3
[INPUT 4] DisplayPort 4
[DUAL] Dual (*1)
[QUAD] Quad (*2)
*1, *2: Refer to “Types of Possible Input Signals”P. 65
Projector unit: press the [INPUT] button to switch the input
0
Play back the selected device to project the image.
To hide the image temporarily
Press the [HIDE] button on the remote control
0
The
“STANDBY/ON” indicator light starts to blink in green. When “LED Indication” is set to “Off”, the indicator does
not blink.
0
Press the [HIDE] button again to resume display of the image.
0
The power cannot be turned off when the image is temporarily hidden.
STANDBY/ON
LIGHT
WARNING
INPUT 1
DISPLAYPORT
INPUT 2 DUAL
INPUT 4INPUT 3 QUAD
1
1 3 2
2
3
This unit
Remote Control
24
Operate