OperationManual

Main Unit - Input Terminals
A B C D GE F H I
Enlarged View of Rear Face
A
[SYNC OUT] terminal
For synchronizing with other equipment.
Outputs L and R sync signals during 3D signal input.
(P. 34
)
B
[SERVICE] terminal
For updating the software using a commercially
available USB flash drive.
C
[RS-232C] terminal (D-sub 9-pin
male)
The projector can be controlled by connecting a PC to
this terminal.
D
[LAN] terminal (RJ-45)
The projector can be controlled by connecting it to a
PC through the computer network for control
commands to be sent to the projector.
E
[DisplayPort 1] input terminal
F
[DisplayPort 2] input terminal
G
[DisplayPort 3] input terminal
H
[DisplayPort 4] input terminal
(20-pin male)
For connecting to devices that support DisplayPort
output. (P. 22)
I
[REMOTE CONTROL] terminal
(stereo mini jack)
This terminal is used to connect the remote control
directly to the projector with the cable.
14
Getting Started