Operation Manual

Viewing Videos
MEMO
0
When you are using this unit, be sure to remove the lens sheet.
0
Connect the power cord, and ensure that the “STANDBY/ON” indicator
lights up in red.
1
Turn on the power
Projector unit: press the A [STANDBY/ON] button
Remote control (sold separately): press the C [ON] button
0
The
“STANDBY/ON” indicator light switches from red to green (light
goes off after the unit starts up).
.
LAMP WARNING
STANDBY/ON
ND
TAN
DBY
LAMP WARNING
STANDBY/ON
ND
TAN
DBY
During lamp startup
“STANDBY/ON” lights up (green)
In standby state
“STANDBY/ON” lights up (red)
2
Choose the image to project
Projector unit: press the [INPUT] button (pressing the button each time
switches the mode)
.
HDMI 1
HDMI 2 Dual
Remote control (sold separately):
Button Terminal
[HDMI 1] HDMI1
[HDMI 2] HDMI2
[COMP.] Dual
0
Play back the selected device to project the image.
To hide the image temporarily
Press the [HIDE] button on the projector unit or remote control (sold
separately)
0
The “STANDBY/ON” indicator light starts to blink in green.
0
Press the [HIDE] button again to resume display of the image.
0
The power cannot be turned off when the image is temporarily hidden.
LAMP WARNING
STANDBY/ON
1
2
3
22
Operate